User manual SONY VPL-SC60M

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. For the customers of VPL-SC60U This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For the customers in the USA This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] The ON/STANDBY indicator lights in red and the projector goes into the standby mode. (If you connect to both the S VIDEO and VIDEO jacks, the signal from the S VIDEO jack is selected. Turn the zoom ring to adjust the size of the picture. Do not look into the lens when the projector lamp is on. To Adjust the volume Cut off the sound Press the VOLUME +/­ keys on the control panel or on the Remoter Commander. the AUDIO MUTING key on the Remote Commander. To restore the sound, press the AUDIO MUTING key again or press the VOLUME + key. the PICTURE MUTING key on the Remote Commander. To restore the picture, press the PICTURE MUTING key again. Cut off the picture To get the clearest picture You can get the suitable picture when a signal from the computer is input. Adjust the signal when the still picture is displayed on the screen. If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture. " appears on the screen when the picture is adjusted properly. The picture may not be adjusted properly depending on the kinds of input signals. Adjust DOT PHASE in the INPUT SETTING menu when you adjust the picture manually. To turn off the power The following message appears to confirm if you want to turn off the power. The message will disappear if you press any key except the I / u key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce the internal heat. Also, the ON/ STANDBY indicator flashes quickly for the first 30 seconds. During this time, you will not be able to turn the power back on with the I / u key. Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red. When you cannot confirm the on-screen message When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / u key on the Remote Commander or on the control panel for about one second. [. . . ] Close the air filter cover securely (see page 37 (GB)). Check that the proper connections have been made (see pages 18 (GB) to 21 (GB)). Check that the proper connections have been made (see pages 18 (GB) to 21 (GB)). Select the input source correctly using the INPUT key (see page 22 (GB)). [. . . ]