User manual SONY VPL-VW1000ES

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. [. . . ] You can select one of nine languages for displaying the menu and other onscreen displays. Open the connector panel, then plug the AC power cord into a wall outlet. Press the I / 1 key to turn on the projector. Press the M or m key to select the MENU SETTING menu, then press the , or ENTER key. Press the M or m key to select "Language, " then press the , or ENTER key. Press the M or m key to select a language, then press the < or ENTER key. The menu disappears automatically if a key is not pressed for one minute. Open the connector panel, plug the AC power cord into a wall outlet, then connect all equipment. The ON/STANDBY indicator lights in red and the projector goes into standby mode. The ON/STANDBY indicator lights in green and the Intelligent Auto-setup starts. Depending on the type of your computer, for example a notebook, or an all-inone LCD type, you may have to switch the computer to output to the projector by pressing certain keys (e. Do not unplug the AC power cord while the fan is still running; otherwise, the fan will stop even though the internal heat is still high, which could result in a breakdown of the projector. On air filter To maintain optimal performance, clean the air filter every 300 hours. This function works when a signal from a computer is input, or when a still picture (except a movie picture) stored in a Memory Stick is projected (VPL-CX5 only). This function does not work when a video signal is input. Move the icon to the point on the image you want to enlarge. Use the arrow key (M/m/</, ) to move the icon. By pressing the + key repeatedly, the image size increases (ratio of enlargement: max. Use the arrow key (M/m/</, ) to scroll the enlarged image. To return the image back to its original size Press the D ZOOM ­ key. Just pressing the RESET key returns the image back to its original size immediately. to freeze the image projected (Freeze function) Press the FREEZE key. [. . . ] Noise may appear on the background depending on the combination of the numbers of dot input from the connector and numbers of pixel on the LCD panel. Inputting the correct signal c Select "Computer, " "Video GBR" or "Component" correctly from INPUT A. C Replace the lamp with a new one (see page 36). C Leave the projector for about two hours with the power on . [. . . ]