User manual SONY VPL-W400Q

[. . . ] ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. for the customers in Canada This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. [. . . ] If you do not intend to use the Remote Commander for a long time, remove the batteries to avoid damage from battery leakage. If a battery has leaked, remove the batteries, wipe the battery compartment dry and replace the batteries with new ones. notes on wireless Remote Commander operation · Be sure that there is nothing to obstruct the infrared beam between the Remote Commander and the projector. The shorter the distance between the Remote Commander and the projector, the wider the angle within which the commander can control the projector. Adjust the height of the projector so that the center of the lens is just below the bottom edge of the screen. Adjust the horizontal positioning of the projector so that the lens is aligned with the horizontal center of the screen. The distance between the lens and the screen varies depending on the size of the screen. This section describes how to connect the projector with a VCR and external active speakers. For details on how to connect other equipment, see page 32. The POWER indicator flashes in green and the fan continues to run for about 1 minute and 30 seconds to reduce the internal heat. The POWER indicator flashes quickly for the first minute. During this time, you will not be able to turn the power back on with the POWER key. After about one minute, you can turn on the power with the POWER key. Wait until the fan stops running and the STANDBY indicator lights in red; then press the MAIN POWER switch to turn off the main power (o OFF). Do not to press the MAIN POWER switch while the fan is still running; the fan will stop while the lamp is still hot, leading to breakdown. To make the lamp life last longer, do not turn off the power at least for about 10 minutes after turning on the power. This projector provides you with the various choices of picture modes. Please select a picture mode taking into account that one which changes the aspect ratio of the original picture will provide a different look from that of the original image. Please also note that if the projector is used for profit or for public viewing, modifying the original picture by switching picture modes may constitute an infringement of the rights of authors or producers which are legally protected by laws. The projector is equipped with an on-screen menu for making various adjustments and settings. About the memory of the settings Use the V or v keys on the control panel to select a menu, then press the b key or the ENTER key. On the Remote Commander, move the joy stick up or down to select a menu, then move it to the right or press the ENTER key. [. . . ] Close the air filter cover securely (see page 33). Check that the proper connections have been made (see pages 14 and 32). Press the MUTING keys to release the muting function (see page 16). Leave the projector for about two hours with the power on. [. . . ]