User manual SONY WALKMAN D-FJ210 QUICK START

[. . . ] One section does not always indicate one-fourth of the battery power. · Depending on operating conditions, the indicator sections of may increase or decrease. CAUTION · INVISIBLE LASER RADIATION WHEN OPEN · DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENT The validity of the CE marking is restricted to only those countries where it is legally enforced, mainly in the countries EEA (European Economic Area). "WALKMAN" is a registered trademark of Sony Corporation to represent Headphone Stereo products. is a trademark of Sony Corporation. Notes on using the dry batteries · Be sure to remove the AC power adaptor. · When the batteries are depleted, replace both batteries with new ones. CD player (front) Strap holes Owner's Record A OPEN DC IN 4. 5 V (external power input) jack The model number and the serial number are located at the rear of the CD player. [. . . ] qs G-PROTECTION Insert the # end first (for both batteries). Remote control 3 VOL +/­ 5 u* Display on CD player 3 VOL+/­ Band 67 8 9 x PRESET RADIO ON/BAND· Play mode LOCAL RADIO OFF Product registration Remaining battery power AVLS For the customers in the USA Please register this product on line at www. sony. com/ productregistration. <http://www. sony. com/productregistration> Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you. 4 . /> (AMS*3/search) (. />· PRESET­/+) qa HOLD 4 . /> PRESET ­/+ Clip Sound mode Track number/ PRESET number Playing time/ Frequency *The button has a tactile dot. Power Sources Note Use only the supplied remote control. You cannot operate this CD player with the remote control supplied with other CD players. 5u (play/pause) To use the AC power adaptor (C) 1 Connect the AC power adaptor (not supplied) to an AC outlet. 6 x (stop) 7 RADIO OFF 8 BAND 9 RADIO ON q; MEMORY C DC IN 4. 5V to an AC outlet AC power adaptor D Label side up To use the batteries (B) Use only the following batteries for your CD player: Dry batteries · LR6 (size AA) alkaline batteries To insert the batteries 1 Open the battery compartment lid inside your CD player. qa HOLD qs G-PROTECTION Set it to ON to protect against sound skipping. *4 *1 AVLS = Automatic Volume Limiter System *2 If the sound is distorted when using the SOUND function, turn down the volume. *3 AMS = Automatic Music Sensor 4 * Sound may skip: ­ if the CD player receives stronger continuous shock than expected, ­ if a dirty or scratched CD is played or ­ when using poor-quality CD-Rs/CD-RWs or if there is a problem with the recording device or application software. (Continue to the reverse side) 2 Insert two batteries by matching the 3 to the diagram in the battery compartment and close the lid until it clicks into place. i Headphones or earphones To remove the CD Remove the CD while pressing the pivot. If it is hard to hear the FM broadcast Press and hold PLAY MODE/ until "LOCAL" appears in the display. Under the normal conditions, press and hold PLAY MODE/ until "LOCAL" disappears from the display. · Do not touch the AC power adaptor with wet hands. · Connect the AC power adaptor to an easily accessible AC outlet. Should you notice an abnormality in the AC power adaptor, disconnect it from the AC outlet immediately. The volume does not increase even if you press VOL + repeatedly. c Press and hold SOUND until "AVLS" disappears from the display. On dry batteries · Do not throw the batteries into fire. · Do not carry the batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the battery are accidentally contacted by a metallic object. · Do not mix new batteries with old ones. · Do not use different types of batteries together. · When the batteries are not to be used for a long time, remove them. · If battery leakage occurs, wipe off any deposit in the battery compartment, and install new batteries. In case the deposit adheres to you, wash it off thoroughly. When listening to the radio on batteries If you connect the external power source plug to the DC IN 4. 5 V jack of your CD player, the CD player will turn off. Turn it on by pressing RADIO ON to continue listening to it. The battery compartment lid is dettached by an accidental drop, excessive force, etc. c Attach it as illustrated below. To turn off the operation beep sound You can turn off the beep sound that is heard from your headphones/earphones when you operate your CD player. Presetting radio stations You can preset up to 51 stations: 30 for FM, 10 for AM, 7 for TV, and 4 for WB. 1 Remove the power source (AC power adaptor, dry batteries) from the CD player. 2 Connect the power source while pressing x. To turn on the beep sound Remove the power source and then connect the power source without pressing x. 1 Press RADIO ON to turn on the radio. or > on the CD player to tune in the station you want. On the CD player · Keep the lens on the CD player clean and do not touch it. If you do so, the lens may be damaged and the CD player will not operate properly. [. . . ] (Press and hold x·RADIO ON/ BAND·RADIO OFF on the remote control. ) To tune in the station quickly Press and hold . or > on the CD player in step 3 until the frequency digits begin to change in the display. The CD player automatically scans the radio frequencies and stops when it finds a clear station. Notes · The interval will not change until you once turn off the radio and then turn it on again. · After changing the tuning interval, you need to preset radio stations again. To improve broadcast reception For TV/WB/FM, extend the headphones cord. Precautions On safety · Should any solid objects or liquid fall into the CD player, unplug it and have it checked by qualified personnel before operating it any further. [. . . ]