User manual SONY WEGA KD-27FS170

[. . . ] Connecting Additional Equipment 2-670-362-21(1) Operating Instructions KD-27FS170 KD-32FS170 KD-36FS170 © 2006 by Sony Corporation User Guide WARNING To reduce the risk of fire or electric shock, do not expose the TV to rain or moisture. Pursuant to FCC regulations, you are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN NOTIFICATION This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Vivid: Select for enhanced picture contrast and sharpness. Standard: Select for a standard picture. Movie: Select for a finely detailed picture. Pro: Select for natural picture and sharpness. on the remote control to directly select picture modes (Vivid, Standard, Movie, Pro). Press Picture Brightness Color Hue Sharpness Color Temp. White tint adjustment Press B to decrease the contrast. Use the V or v buttons to highlight one of the following options, then press to select it. Neutral: Gives white colors a neutral tint. Cool: Gives white colors a blue tint. ClearEdge VM v buttons to highlight: High, Low, or Off, then press Sharpens picture definition to give objects a crisp, clean edge. Use the V or to select it. Available only for KD-32FS170 and KD-36FS170 models. 21 Analog Menus Using the Channel Setup To access the Channel Setup Menu, use the following steps: To Display To Highlight Menu Channel Setup Favorite Channels Cable:On Channel Fix:Off Auto Program Channel Show/Hide Channel Label To Select Press v to highlight an option, then press Favorite Channels Quick access to analog favorite channels . Move Select End Applies to analog channels only. To set up favorite digital channels, see page 31. To set up your analog Favorite Channels list: 1 Use the V or v buttons to highlight the position (1-5) where you want to set a 2 3 favorite channel, then press . Use the V or v buttons to find the channel you want to add to your favorite channels. The TV will automatically change to the selected channel and assign it to the selected position (1-5). Press B to return to the Channel Setup menu or press to exit. Cable 4 Use the V or v buttons to highlight one of the following options, then press to select it. On: Off: Select if you are receiving cable channels with a CATV cable. Select if you are using a TV antenna. After changing the Cable setting the first time, you will need to run Auto Program. For digital channels, see page 31. Channel Fix Not available when in digital tuning mode. Use the V or v buttons to highlight one of the following options, then press to select it. Off: 2-6: Video 1: Channel Fix is not set. "Fix" your TV's channel setting to 2­6 (VHF/UHF input) and use the cable box or satellite receiver to change channels. Select from available video inputs when you have connected video equipment (e. g. , a satellite receiver) and you want your TV fixed to it. You cannot use Favorite Channels, Cable, Channel Show/Hide, or Channel Label when Channel Fix is set. Auto Program Applies to analog channels only. To Auto Program digital channels, see page 31. [. . . ] Some electronic equipment creates electrical noise, which can interfere with TV reception. Check your outdoor antenna or call your cable service. Some wide-screen programs are filmed in aspect ratios that are greater than 16:9, such as 2. 35:1. (This is especially common with theatrical releases). [. . . ]