User manual SONY WEGA KLV-S40A10

[. . . ] 2-650-915-11(2) LCD Color TV Operating Instructions KLV-S40A10 © 2005 Sony Corporation Owner's Record The model and serial numbers are located at the rear of the TV. Record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. Serial No. Contacting Sony If, after reading the following instructions, you have additional questions related to the use of your Sony® TV, please call the following number. [. . . ] When all the receivable channels are stored, the Show/Hide Channels settings appear. To scan available VHF/UHF antenna channels instead of the cable TV channels 1 Select Settings in WEGA GATE, then go to Channel settings. 3 Start Auto Program by pressing CH +. To perform Auto Program again, follow the above instructions. Depending on your signal source, be sure to set Cable to On or Off accordingly (see page 53). The Initial Setup menu will appear each time the TV is turned on until you complete the scanning for the available channels. 30 Watching the TV Button Descriptions Button Description MTS/ POWER MUTING DISPLAY SAP POWER SAVING FREEZE TV/ VIDEO 1 MUTING 2 DISPLAY 1 2 3 4 5 6 3 POWER SAVING RETURN WEGA GATE 4 FREEZE 7 8 FUNCTION F1 5 JUMP 9 F2 0 qa qs TOP MENU MENU GUIDE SLEEP 6 RETURN 7 WEGA GATE 8 FUNCTION Buttons 9 DVD/VCR Operating Buttons Press to mute the sound. Press again or press VOL + to restore the sound. Press once to display the current channel number, channel label, time and Wide Mode settings. The OSD (on screen display) will be canceled after a few seconds or press again to immediately cancel the display. Press repeatedly to cycle through the power saving modes: Standard, Reduced, Picture Off. The current program appears in the sub screen when freeze is selected. Press repeatedly to restore the picture. You can use this feature to write down information such as phone numbers, recipes, etc. Some functions will not be available in freeze. Press to jump back and forth between two channels. The TV alternates between the current channel and the last channel that was selected. Press to go back to the previous screen when displaying settings. See "Introducing WEGA GATE" on page 42. Press to have the remote control operate the equipment you want. See "Programming the Remote Control" on page 34. When FUNCTION is switched on DVD/VCR, these buttons operate the video equipment you have programmed into the remote control. See "Using Other Equipment with Your Remote Control" on page 36. m Rewind N Play M Fast forward X Pause x Stop z Record Press to display the top menu of the DVD disc. Press to display the DVD disc menu or setup menu of the connected Satellite Receiver. For further information, refer to the operating manual of the connected equipment. [. . . ] Make sure that the antenna is connected using the supplied 75-ohm coaxial cable. Keep the antenna cable away from other connecting cords. Do not use 300-ohm twin lead cables as interference may occur. This is caused by video head interference. [. . . ]