User manual SONY WM-EQ7WP

[. . . ] Playing a tape recorded with the Dolby* B NR system Hold down SOUND until ";" appears in the display. To cancel Dolby B NR, hold down SOUND again until ";" disappears. * Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. [. . . ] 1 Insert the supplied rechargeable battery NH-14WM into the rechargeable battery compartment with correct polarity. Plug in the charger to the house current (mains), and place the main unit on the charger. About 30 minutes of charging will charge the battery to last about 3 hours. This Walkman detects the side being played using the cavity on side A of the cassette. If there is no cavity on the cassette or the cavity is on side B, the detection will not be done correctly. Wear the "L" marked side to the left ear and the "R" marked side to the right ear. If the earphones do not fit to your ears or the sound is unbalanced, adjust the earphones to fit to your ears firmly. The AMS and the Repeat Single Track functions detect a blank of 4 seconds or longer between the tracks. If there is noise between the tracks, these functions may not recognize the blank and may not operate. â· When "s" is displayed , both sides of the tape is played repeatedly. â· When "d" is displayed, both sides of the tape is played once (if you start from side B, only side B will be played). You cannot adjust the playback mode during fast-forward or rewind. If the sound becomes distorted in the SURROUND mode, select other modes. â· You cannot change the mode during fast-forward or rewind. Condition There is enough battery power. The VOLUME switch on the main unit has three steps; AVLS MIN, NORM, and MAX. generally , set it to NORM and make fine volume adjustments on the remote control. Set it to MAX when the recording level is low. [. . . ] Set it to MAX when the recording level is low. The sound cannot be turned down all the way. Stop playback Play the next track from the beginning (AMS*) Replace it with a new battery. [. . . ]