User manual SONY WM-EX20

[. . . ] Likewise, if there is a low-level segment within a track, these functions may recognize it as a blank space. Three times during stop (One short beep, then repeated sets of two short beeps) When you are not sure of the playback status, press the operation button once. [. . . ] Play the other side from the beginning (Skip Reverse function) Play the same side from the beginning (Rewind Auto Play function) With each press, the indications change as follows: SURROUND (Mega Surround*): Dynamic Surround Sound MB (Mega Bass): emphasizes bass sound (moderate effect) RV (Sound Revitalizer): emphasizes treble sound none: normal (no effect) You can charge the battery about 300 times. note Do not use the unit while charging. â· If you play back the tape while charging, the battery will not be charged. â· The tape may stop in the middle of fast-forwarding or rewinding if it is done during charging. â· The sound may contain noise if a tape is played back with the main unit placed on the charger. REW for more than a second during stop ("REW" flashes) X on the remote control is pressed during fast forward or rewind, the Walkman switches to playback. You can adjust the playback direction mode (s or d) as well as the BL SKIP mode (on or off). Make sure the HOLD function of the remote control is turned off. If it is on, slide the HOLD switch on the remote control to turn it off . You can operate the tape with the operation button on the main unit. If the operation button is locked, slide HOLD/OPERATION switch in the direction of "B" to release hold. To Press the operation button (beeps in the earphones) Once For more than a second during playback (Switching to side A: one short beep/ Switching to side B: two short beeps) Once (One short beep) Twice during playback (One short beep, then repeated sets of a short beep and a long beep) Three times during playback (One short beep, then repeated sets of two short beeps and a long beep) Four times during playback (Repeated sets of a short beep, a long beep and a short beep when rewinding) When the battery is exhausted, tape playback will become unstable and noisy, and then the tape will stop. [. . . ] If the cassette holder is opened when the tape is running, the tape may loosen and be damaged. When you insert a charged battery, the battery remainder mark may show " " even if it is not fully charged. [. . . ]