User manual SONY WM-EX677

[. . . ] REPEAT during playback Stop playback Fast forward** Rewind** Repeat the current track (Repeat Single Track function) p FF· REPEAT 2 seconds or more during playback To stop a single repeat, press it again. fF· AMS 2 seconds or more during stop REW· AMS 2 seconds or more during stop To play a tape recorded with the Dolby*B NR system While holding down FUNCTION, press p. [. . . ] note · Certain countries may regulate disposal of battery used to power this product. When adjusting the volume on the remote control Set the VOLUME control on the Walkman to around 6. Note on the cassette holder When opening the cassette holder, make sure the tape is stopped, then slide the OPEN switch. The BL SKIP and a NR settings are stored as long as the battery is not replaced. To Play the next track/ succeeding 9 tracks from the beginning Play the current track/previous 8 tracks from the beginning Press FF· When the battery weakens, the BATT lamp will flash and tape playback will become unstable and noisy. When you remove and reinsert a rechargeable battery, the BATT lamp may light up temporarily even if it has little battery power left. After a while, the BATT lamp will change to flashing status. ⷠThe BATT lamp may temporarily flash or go off during use in extremely low temperatures. If the cassette holder is opened when the tape is running, the tape may loosen and be damaged. While holding down FUNCTION, press oe· rEPEAT repeatedly. With each press, the sound indication lamps light up as follows. (The indications go off when you release FUNCTION. [. . . ] P twice track (Repeat Single during playback To stop a single Track function) repeat, press oe· p once. Play the other side FF 2 seconds or from the beginning more during stop (Skip Reverse function) Play the same side REW 2 seconds or from the beginning more during stop (Rewind Auto Play function) P is pressed during fast forward or rewind, the Walkman switches to playback. [. . . ]