User manual SONY WM-FX488

[. . . ] 3 Press PRESET/TUNING +/­ to tune in to the desired station. If the signal is strong, you can scan for stations. Press MENU repeatedly to set the cursor in the display to TUNE MODE and press SET to display "MANUAL". Then hold down PRESET/TUNING +/­ for a few seconds. Printed using VOC (Volatile Organic Compound)-free vegetable oil based ink. "WALKMAN" is a registered trademark of Sony Corporation to represent Headphone Stereo products. [. . . ] 83. 6 x 112. 0 x 28. 3 mm (3 3/8 × 4 1/2 × 1 1/8 inches) excl. projecting parts and controls · Mass Approx. 138 g (4. 9 oz) (main unit only) · Supplied accessories Stereo headphones or Stereo earphones (1) Carrying case with belt clip(1) Design and specifications are subject to change without notice. Battery life* (approximate hours) Sony alkaline LR6 (SG)** Sony R6P (SR) Tape playback 35 9 14 Radio reception 40 Presetting Automatically Scanned Stations 1 Press TV/WB or FM/AM. 2 Press and hold ENTER for more than 3 seconds. Preset number 1 will flash in the display and the Walkman starts scanning the stations from the lower frequencies and stops for about 4 seconds when a station is received. 3 If you wish to preset the currently received station, press ENTER while the preset number is flashing. The received station is preset on preset number 1 and the unit starts scanning for the next receivable station. 4 Repeat Step 3 until all receivable stations are preset. The radio is turned off at the same time. Notes · If stations are already stored, the newly preset stations replace the old ones when the above procedure is completed. · If stations cannot be preset automatically, preset them manually. * Measured value by the standard of JEITA (Japan Electronics and Information Technology Industries Association). (Using a Sony HF series cassette tape) **When using a Sony LR6(SG) "STAMINA" alkaline dry battery (produced in Japan). Note · The battery life may be shorter depending on the operating condition, the surrounding temperature and battery type. Scanning the preset radio stations -- DAPS (Digital Auto Preset Scanning) 1 Press TV/WB or FM/AM repeatedly to select the desired band and to turn on the radio. 2 Press and hold TV/WB or FM/AM pressed in step 1 for 2 seconds or more. The preset stations of the selected band will be played for about 5 seconds each. (During DAPS the indicators in the display flash. ) 3 Press TV/WB or FM/AM again to select the station while the desired preset station is being played. Notes · If there are no stations stored, the DAPS function does not work. · Until a station is selected in step 3, the DAPS function turned on in step 2 will continue. · In step 2 or 3, if you select a band which you did not select in step 1 by pressing TV/WB or FM/AM, the newly selected band will be played normally. On headphones/earphones Road safety SONY WM-FX488 Tested to Comply Do not use headphones/earphones while driving, With FCC Standards cycling, or operating any motorized vehicle. [. . . ] This may cause malfunction of the unit or sound deterioration. · The LCD display may become hard to see or slow down when using the unit at high temperatures (above 40°C/104°F) or at low temperatures (below 0°C/32°F). At room temperature, the display will return to its normal operating condition. [. . . ]