User manual SONY WM-GX400

[. . . ] The CE mark on the unit is valid only for products marketed in the European Union. To use external power ⷠConnect the AC power adaptor AC-E30HG (not supplied) to the DC IN 3V jack and to the wall outlet. Check your local voltage and the shape of plug before purchasing. [. . . ] These controls only change the sound level you hear. ⷠActual recording will start about 2 seconds after you press z REC. Press z REC about 2 seconds before the moment you want to start recording, or you will miss the beginning of your recording. ⷠWhen recording on both sides, recording will not be made for about 10 seconds while the tape is switching sides. Since its cord serves as an FM antenna, connect the headphones/earphones even when using the speakers. Note For customers who purchased the "Sony World Model": Switch the area to "J" when you use this Walkman in Japan. Do not carry the dry batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the batteries are accidentally contacted by a metallic object. ⷠWhen you are not going to use your Walkman for a long time, remove the batteries to prevent damage from battery leakage and corrosion. Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or sand, moisture, rain, mechanical shock, or leave it in a car with its windows closed. ⷠDo not use cassettes longer than 90 minutes except for long continuous playback. ⷠThe LCD display may become hard to see or slow down when using the unit at high temperatures (above 40°C/104°F) or at low temperatures (below 0°C/32°F). At room temperature, the display will return to its normal operating condition. ⷠIf the unit has not been used for a long time, set it in the playback mode to warm up for a few minutes before you start using again. ⷠKeep personal credit cards using magnetic coding or springwound watches, etc. , away from the unit to prevent possible damage from the magnet used in the speaker. [. . . ] Remove the batteries for 2 minutes or more, and then insert them again. If this does not solve the problem, remove the batteries and leave the unit without batteries for 10 minutes or more, and then insert them again. In either case, preset the stations again, since the preset stations are erased from the memory. [. . . ]