User manual SONY WM-GX677

[. . . ] The battery remainder mark may temporarily show a lower level during fast forwarding or rewinding or use in extremely low temperatures. specifications for AC-E15HG vary for each area. Check your local voltage and the polarity of the plug before purchasing. Wear the "L" marked side to the left ear and the "R" marked side to the right ear. [. . . ] In either case, use a new or fully charged battery. To record from the radio Tune in to the station you want to record (see "Listening to the Radio"). "REC" appears in the display and recording starts after about 2 seconds. If you have started recording from the FWD side, recording will switch to reverse side automatically at the end of the FWD side. You can monitor the recording sound through headphones/ earphones. You may hear some noise in the monitor sound in the RV, MB, or GRV mode, but this does not affect recording. Sound emphasis (RV, MB, or GRV), AVLS and Dolby B NR settings do not affect recording. Actual recording will start about 2 seconds after you slide REC. Slide REC about 2 seconds before the moment you want to start recording, or you will miss the beginning of your recording. When recording on both sides, recording will not be made for about 10 seconds while the tape is switching sides. If you do, the sound may be distorted when you play back the tape, or the previous recording may not be erased completely. Do not connect or disconnect the earphones to/from 2REMOTE while recording from the radio. The recording condition may change abruptly, or noise may be recorded. To avoid noise interference, do not place it near a lamp cord or a fluorescent lamp when recording with the microphone. All other operation cannot be made while recording. Break off the tabs from side A and/or B. To reuse the tape for recording, cover the tab hole with adhesive tape. If the reception is still not good, press MENU repeatedly to set the cursor in the display of the main unit to FM MODE . Then press SET to choose from "MONO" (monaural), "LOCAL" or none (stereo) mode for best reception. Press MENU on the main unit repeatedly and set "__" ( the cursor) in the display of the main unit to TUNE MODE. To use preset tuning, preset stations first (see "Tuning in to the Readypreset Stations for Each Area" or "Presetting Radio Stations"). To turn on the radio, press the jog lever for more than one second (while the tape is in stop mode only). [. . . ] To display the sound emphasis status on the remote control Press MENU to enter the menu mode. Press SET repeatedly to select the sound emphasis of your choice. If the sound becomes distorted with the GRV effect, select MB or NORM (no message). The tape counter is displayed on the main unit during playback, recording, fast forward, rewind, and stop (except when the radio is turned on). [. . . ]