User manual SONY WM-GX788

[. . . ] 3-255-270-11(1) A E FWD (forward) side REV (reverse) side Radio Cassette-Corder Operating instructions Note Tapes recorded with setting to " " cannot be played properly on a cassette player/ tape recorder without this function. When to replace/ charge the battery C Replace or charge the battery when " " flashes in the display. Battery life* (Approx. hours) Playing a Tape E 1 Insert a cassette and if the HOLD function is on, slide the HOLD switch in the opposite direction of the arrow to unlock the controls. 2 Press MENU repeatedly to set "__" (the cursor) in the display to REC/PB. Then " press SET to select " or none (normal speed) which is the same position as that used for recording. [. . . ] Then " press SET to select " or none (normal speed). Normal (no indication) (4. 8cm/s): for optimum sound. Do not use any other AC power adaptor. Troubleshooting The sound drops out or comes with excessive noise. · Clean the headphones/earphones and remote control plugs. · Charge the battery or replace the dry battery with a new one. A beep sounds and recording is not possible when REC is slid. · If the tab of the tape is broken off, cover the tab hole with adhesive tape. The display and the operations are not normal. · Remove the power sources for 15 seconds or more, and then set them again. The radio and playback operates but recording is not possible. · This condition may occur when the battery becomes weak. Replace or charge the battery. Specifications Radio section Frequency range FM: 76. 0 - 90. 0 MHz (Japan) 87. 5 - 108 MHz (other countries/regions) AM: 531 - 1 710 kHz (Japan) 530 - 1 710 kHz (North, Central, and South America) 531 - 1 602 kHz (other countries/regions) Presetting Automatically Scanned Stations 1 Press RADIO ON/BAND to turn on the radio. 2 Press RADIO ON/BAND repeatedly to select AM or FM. 3 Press and hold ENTER for more than 3 seconds. Preset number 1 will flash in the display and the main unit starts scanning the stations from the lower frequencies and stops for about 5 seconds when a station is received. 4 If you wish to preset the currently received station, press ENTER while the preset number is flashing. The received station is preset on preset number 1 and the unit starts scanning for the next receivable station. 5 Repeat step 4 until all receivable stations are preset. To stop scanning Press RADIO OFF. The radio is turned off at the same time. Notes · If stations are already stored, the newly preset stations replace the old ones when the above procedure is completed. · If stations cannot be preset automatically, preset them manually. Playing the Preset Radio Stations 1 Press RADIO ON/BAND to turn on the radio. 2 Press RADIO ON/BAND repeatedly to select AM or FM. 3 Press MENU repeatedly to set the cursor in the display to TUNE MODE. [. . . ] The frequency digits will flash in the display. 4 While the frequency digits are flashing, tune in to a station you wish to store using TUNE/PRESET + or ­ and press ENTER. The preset number will flash in the display. 1 Press RADIO ON/BAND to turn on the radio. 2 Press RADIO ON/BAND repeatedly to select AM or FM. [. . . ]