User manual SONY WM-AF58

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ⭠Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Use a soft cloth slightly moistened in water. Remove the batteries for 30 seconds or more, and then insert them again. If this does not solve the problem, remove the batteries and leave the unit without batteries for 30 minutes or more, and then insert them again. 4 Repeat Step 3 until all receivable stations are preset. If stations are already stored, the newly preset stations replace the old ones when the above procedure is completed. *Note on fast-forward and rewind If you leave the unit after the tape has been wound or rewound, the batteries will be consumed rapidly. Do not open the cassette holder while the tape is running. To play Both sides repeatedly Both sides once from the side facing the cassette holder Select s d 3 While the frequency digits and the preset number are flashing, tune in to a station you wish to store using TUNING+/­, and select a preset number using PRESET+/­. If you cannot complete step 3 or 4 while the indications are flashing, repeat from step 2. ⷠIf a station is already stored, the new station replaces the old one. Make sure that the tape has stopped completely. If you keep pressing TUNING+/­ for a few seconds, the Walkman will start tuning to the stations automatically. If the sound is distorted when MEGA BASS is activated, turn down the volume of the main unit or select normal mode. [. . . ] Make sure that the tape has stopped completely. If you keep pressing TUNING+/­ for a few seconds, the Walkman will start tuning to the stations automatically. If the sound is distorted when MEGA BASS is activated, turn down the volume of the main unit or select normal mode. ⷠBass emphasis may not show great effect if the volume is turned up too high. [. . . ]