User manual SONY WM-DDT1

[. . . ] ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] **If you leave the Walkman after the tape has been wound or rewound, the batteries will be consumed rapidly. Do not open the cassette holder while the tape is running. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce volume or discontinue use. Then, press SET to turn MB (mega bass) on. with each press , the indications change as follows. MB (mega bass) : emphasizes bass sound No message: off (normal) notes · If the sound is distorted with the mode "MB", turn down the volume or select normal mode. Bass emphasis may not show great effect if the volume is turned up too high. This will allow you to hear outside sounds and to be considerate to the people around you. To clean the tape head and path, Use the cleaning cassette CHK-1W/C-1KW (not supplied) every 10 hours of use. To clean the exterior, use a soft cloth slightly moistened in water. Preset number 1 will flash in the display and the Walkman starts scanning the stations from the lower frequencies and stops for about 3 seconds when a station is received. 3 If you wish to preset the received station, press ENTER while the preset number is flashing. The received station is preset on preset number 1 and the unit starts scanning for the next receivable station. 4 Repeat Step 3 until all receivable stations are preset. If stations are already stored, the newly preset stations replace the old ones when the above procedure is completed. Before opening or closing the cassette holder, be sure to wipe off water, dust or sand on the exterior of the Walkman. (The Walkman is not water-resistant with the cassette holder open. ) · Since water in the headphones/earphones jack may cause rust, cover it with the attached rubber cap when the headphones/ earphones are not in use. Since the Walkman is airtight, you may not be able to open the cassette holder because of sudden change in air pressure inside the Walkman, which happens after being transported on a plane or moving from a warm place to a cold place. The supplied headphones/earphones are not meant to be immersed in water or come in continuous contact with water. If they are accidentally dropped into water or get wet, dry them with a soft cloth. [. . . ] If the Walkman or the headphones/earphones are immersed in salt water, be sure to wash them in non-running fresh water. Never wash them under running water, and never use soap or detergent. Any sand or dust on the rubber packing will prevent the cassette holder from closing tightly, and water may leak in. 2 Release the catch to open the battery compartment lid and insert two size AA (R6) dry batteries with correct polarity. [. . . ]