User manual SONY WM-F2085

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] 3 Release the catch to open the battery compartment lid and insert one size AA (R6) dry battery with correct polarity. Belt clip D When to replace the battery D " Replace the battery with the new one when " flashes in the display. To replace the battery On water resistance · Before opening or closing the cassette lid, be sure to wipe off water, dust or sand on the exterior of the Walkman. (The Walkman is not water-resistant with the cassette lid open. ) · Since water in the headphones/earphones jack may cause rust, cover it with the attached rubber cap when the headphones/earphones are not in use. · Since the Walkman is airtight, you may not be able to open the cassette lid because of sudden change in air pressure inside the Walkman, which happens after being transported on a plane or moving from a warm place to a cold place. To open the cassette lid see "Troubleshooting". · The supplied headphones/earphones are not meant to be immersed in water or come in continuous contact with water. If they are accidentally dropped into water or get wet, dry them with a soft cloth. · If the Walkman or the headphones/earphones are immersed in salt water, be sure to wash them in non-running fresh water. Never wash them under running water, and never use soap or detergent. · Any sand or dust on the rubber packing will prevent the cassette lid from closing tightly, and water may leak in. · We recommend the packing to be changed every year. Replacement packing is available at an authorized Sony Service Facility. 1 Release the catch to open the battery compartment lid. 3 While the frequency digits are flashing, tune in to a station you wish to store using PRESET/TUNING + or ­ and press ENTER. The preset number will flash in the display. 4 While the preset number is flashing, select the preset number you want using PRESET/TUNING + or ­ and press ENTER. Notes · If you cannot complete step 3 or 4 while the indications are flashing, repeat from step 2. · If a station is already stored, the new station replaces the old one. * Playback will switch automatically to the opposite side when the tape reaches the end of the side. **If you leave the Walkman after the tape has been wound or rewound, the battery will be consumed rapidly. Note Do not open the lid of the cassette compartment while the tape is running. Playing the Preset Radio Stations 1 Press AM/FM or TV/WB. 2 Press MENU repeatedly to set the cursor in the display to TUNE MODE. Then press SET to choose "PRESET". 3 Press PRESET/TUNING + or ­. To cancel a stored station 1 Follow the procedure above and in step 3, select the preset number you want to cancel and then press ENTER. The frequency digits will flash in the display. 2 Press and hold PRESET/TUNING + or ­. [. . . ] The preset stations of the selected band will be played for about 5 seconds each. (During DAPS the indicators in the display flash. ) 3 Press AM/FM or TV/WB again to select the station while the desired preset station is being played. Notes · If there are no stations stored, the DAPS function does not work. · Until a station is selected in step 3, the DAPS function turned on in step 2 will continue. · In step 2 or 3, if you select a band which you did not select in step 1 by pressing AM/FM or TV/WB, the newly selected band will be played normally. Specifications · Frequency range TV: 2 - 13 ch WB (weather): 1 - 7 ch FM: 87. 5 - 108 MHz AM: 530 - 1 710 kHz · Power requirements 1. 5 V DC, battery size AA (R6) × 1 · Dimensions (w/h/d) Approx. [. . . ]