User manual SONY WM-F701C

[. . . ] * If you leave the unit after the tape has been wound or rewound, the battery will be consumed rapidly. Do not open the cassette holder while the tape is running. You can preset up to 35 stations and you can divide these stations into 5 groups, 7 stations in each group. [. . . ] If stations are already stored, the newly preset stations replace the old ones when the presetting is completed. Press and hold GP +/GP ­ for one second or more to display the current group number. The group number and then the frequency digits will be displayed. C 2 Press GP +/GP ­ to select the group for which you want to preset the stations. 3 Press and hold ENTER for more than 3 seconds. Preset number 1 will flash in the display and the Walkman starts scanning the stations from the lowest frequencies and stops for about 3 seconds when a station is received. 4 If you wish to preset the received station, press ENTER while the preset number is flashing. The received station is preset on preset number 1 and the unit starts scanning for the next receivable station. 5 Repeat step 4 until all receivable stations are preset. At room temperature, the display will return to its normal operating condition. ⷠIf the unit has not been used for a long time, set it in the playback mode to warm it up for a few minutes before you start using it again. 6 g (main unit only) Supplied accessories Stereo headphones or earphones (1) Carrying case with belt clip (1) Design and specifications are subject to change without notice. (Using a Sony HF series cassette tape) ** When using Sony LR6(SG) alkaline dry batteries (produced in Japan) The battery life may be shorter depending on the operating condition, the surrounding temperature and battery type. Do not use headphones/earphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your headphones/earphones at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations. 2 Press GP +/GP ­ to select the group for which you want to cancel the preset station. [. . . ] 2 Press GP +/GP ­ to select the group for which you want to cancel the preset station. Keep holding down the button until "- - - -" is displayed. 5 Select the preset number you want to cancel using PRESET NUMBER +/­ and press ENTER. [. . . ]