User manual SONY WM-FX290

[. . . ] 2 Press FM/AM or TV/WB (weather band) repeatedly to select the desired band and to turn on the radio. 3 For manual tuning: 1 Press MENU repeatedly to set the cursor in the display to TUNE MODE and press SET to choose "MANUAL". 2 Press PRESET/TUNING + or ­ repeatedly to tune in to the desired station. [. . . ] · Bass emphasis may not show great effect if the volume is turned up too high. * Measured value by the standard of JEITA (Japan Electronics and Information Technology Industries Association). (Using a Sony HF series cassette tape) **When using a Sony LR6 (SG) alkaline dry battery (produced in Japan). Note The battery life may be shorter depending on the operating condition, the surrounding temperature and battery type. Presetting Radio Stations You can preset up to 40 stations (7 for TV, 4 for WB, 24 for FM and 5 for AM ). i HOLD VOL* x STOP M FF N PLAY** m REW ENTER PRESET/TUNING +/ ­ SET RADIO OFF TV/WB (weather) MENU FM/AM Scanning the Preset Radio Stations -- DAPS (Digital Auto Preset Scanning) 1 Press FM/AM or TV/WB repeatedly to select the desired band and to turn on the radio. 2 Press and hold FM/AM or TV/WB pressed in step 1 for 2 seconds or more. The preset stations of the selected band will be played for about 5 seconds each. (During DAPS the indicators in the display flash. ) 3 Press FM/AM or TV/WB again to select the station while the desired preset station is being played. Notes · If there are no stations stored, the DAPS function does not work. · Until a station is selected in step 3, the DAPS function turned on in step 2 will continue. · In step 2 or 3, if you select a band which you did not select in step 1 by pressing FM/AM or TV/WB, the newly selected band will be played normally. Presetting Automatically Scanned Stations 1 Press FM/AM or TV/WB repeatedly to select the desired band and to turn on the radio. 2 Press and hold ENTER for more than 3 seconds. Preset number 1 will flash in the display and the Walkman starts scanning the stations from the lower frequencies and stops for about 5 seconds when a station is received. 3 If you wish to preset the currently received station, press ENTER while the preset number is flashing. The received station is preset on preset number 1 and the unit starts scanning for the next receivable station. 4 Repeat Step 3 until all receivable stations are preset. To stop scanning Press RADIO OFF. The radio is turned off at the same time. Notes · If stations are already stored, the newly preset stations replace the old ones when the above procedure is completed. · If stations cannot be preset automatically, preset them manually. * There is a tactile dot beside VOL on the main unit to show the direction to turn up the volume. ** The button has a tactile dot. Precautions On batteries · Do not carry dry batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the batteries are accidentally contacted by a metallic object. · When you are not going to use your Walkman for a long time, remove the battery to prevent damage from battery leakage and corrosion. On handling · Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or sand, moisture, rain, mechanical shock, or in a car with its windows closed. [. . . ] 3 Press PRESET/TUNING + or ­. To cancel a stored station 1 Follow the procedure above and in step 3, select the preset number you want to cancel and then press ENTER. The frequency digits will flash in the display. 2 Press and hold PRESET/TUNING + or ­. [. . . ]