User manual SONY WM-FX496ST

[. . . ] ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ­ Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. [. . . ] 3 Press RADIO ON/BAND repeatedly to select TV, WB (Weather), FM or AM. 4 Press TUNING +/­ to tune in to the desired station. Hold down TUNING +/­ for a few seconds to scan for stations. To turn off the radio Press x·RADIO OFF. SET MENU ENTER VOL Presetting Stations Manually FWD Y·x (RADIO ON/BAND·OFF) VOL HOLD FF/PRESET + REW/PRESET ­ REV OPEN MB MODE TAPE AVLS FM MODE 1 Press RADIO ON/BAND to turn on the radio. 2 Press RADIO ON/BAND repeatedly to select TV, Weather, FM or AM. The frequency digits and a preset number flash in the display. 4 While the frequency digits and the preset number are flashing, tune in a station you wish to store using TUNING +/­, and select a preset number using PRESET +/­. 5 While the frequency digits and the preset number are flashing, press ENTER. Notes · If you cannot complete step 4 or 5 while the indications are flashing, repeat from step 3. · If a station is already stored, the newly preset station will replace the old one. To cancel the stored station To improve the broadcast reception D · For TV/WB (Weather)/FM: Extend the headphones/earphones cord (antenna) or remote control cord (antenna). If the reception is still not good, press MENU repeatedly to set the cursor in the display to FM MODE. Then press SET to switch between "LOCAL" and none (DX) for best reception. · For AM: Reorient the unit itself. HOLDB Plug in firmly. Follow the procedure above and in step 4, instead of tuning in a station, press and hold TUNING +/­ until "- - - -" is displayed and select the preset number you want to cancel using PRESET +/­. Press ENTER while "- - - -" is flashing. To operate from the remote control TUNING+/­ TUNING Y Y x/RADIO OFF REW x RADIO OFF FF PRESET RADIO ON FF/PRESET+ RADIO ON /BAND REW/PRESET ­ PRESET BAND To turn on the radio, press RADIO ON/ BAND·OFF for more than one second (only while the tape is in stop mode). To select the band, press RADIO ON/BAND·OFF for more than one second while the radio is on. To tune in or recall a preset station, press PRESET + or ­. To turn off the radio, press RADIO ON/ BAND·OFF. Note Playing the preset radio stations 1 Press RADIO ON/BAND to select the band. [. . . ] You should exercise extreme caution or discontinue use in potentially hazardous situations. Preventing hearing damage Do not use headphones/earphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce volume or discontinue use. Caring for others Keep the volume at a moderate level. [. . . ]