User manual SONY WX-C55

[. . . ] Changer Control Audio Master Operating Instructions US Owner's Record The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. WX-C55 Serial No. For installation and connections, see the supplied installation/connections manual. WX-C55 1999 by Sony Corporation Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Each time you press (MODE), the band changes as follows: B FM1 B FM2 B AM1 B AM2 Receiving the memorized stations 1 2 3 Press (SOURCE) repeatedly to select the tuner. Press (MODE) repeatedly to select the band (FM1, FM2, AM1, or AM2). Press the number button ((1) to (6)) momentarily where the desired station is stored. 3 Press (SENS/BTM) for two seconds. The unit stores stations in the order of their frequencies on the number buttons. A beep sounds when the setting is stored. Notes · The unit does not store stations with weak signals. If only a few stations are received, some number buttons will retain their former setting. Rotate and hold the control until you locate the specific point in a track, then release it to start playback. Rotate and hold the control to tune in a specific station. (SOURCE) (MODE) Every time you press (SOURCE), the source changes as follows: B TUNER B CD B MD B TAPE By pushing in and rotating the control (the PRESET/DISC control) Pressing (MODE) changes the operation in the following ways: · · · · Tuner: FM1 t FM2 t AM1 t AM2 CD unit: CD1 t CD2 t . . . Tape: tape transport direction Tip You can turn on this unit by pressing (SOURCE) on the rotary commander. Push in and rotate the control to: ·Receive the stations memorized on the preset buttons. ·Change the disc. 12 Other operations Rotate the VOL control to adjust the volume. Press (ATT) to attenuate the sound. OFF Adjusting the sound characteristics 1 Select the item you want to adjust by pressing (SOUND) repeatedly. Each time you press (SOUND), the item changes as follows: B VOL (volume) FAD b (front-rear) Press (SOUND) to select the volume and adjust the sound characteristics. B BAS (bass) B TRE (treble) BAL b (left-right) Press (OFF) to turn off the unit. 2 Adjust the selected item by rotating the jog roller. Press (DSPL) to change the display items. Adjust within three seconds after selecting. (After three seconds the jog roller will again serve as the volume control. ) Changing the operative direction The operative direction of controls is factoryset as in the illustration below. To increase To decrease If you need to mount the rotary commander on the right side of the steering column, you can reverse the control's operative direction. Press (SOUND) for two seconds while pushing in the VOL control. 13 Changing the sound and beep tone Boosting the bass sound -- D-Bass You can enjoy clear and powerful bass sounds. The D-bass function boosts the low frequency signal with a sharper curve than conventional bass boost. You can hear the bass line more clearly even if the vocal sound is the same volume. You can emphasize and adjust the bass sound easily. Level D-BASS 3 D-BASS 2 D-BASS 1 Selecting the spectrum analyzer The sound signal level is displayed on a spectrum analyzer. You can select from 8 display patterns . During playback, press (SA) to select a desired setting. Each time you press (SA), the setting changes as follows: B SA­1 SA* b B SA­2 SA­8 b B SA­3 . . . b * Patterns SA-1to SA-8 appear for 10 seconds each in sequence. 0dB Frequency (Hz) Adjusting the spectrum analyzer level You can select from three spectrum analyzer levels. During playback, press (SA) for two seconds. Each time you press and hold (SA) for two seconds, the displayed item changes as follows: B L­1 B L­2* B L­3 Adjusting the bass curve Press (D-BASS) repeatedly to select the desired bass curve. [. . . ] ·The CD is forcibly inserted upside down or in the wrong way (MD). The ambient temperature exceeds 50°C (122°F). ·The unit is installed at an angle of more than 20°. ·The unit is not installed in a sturdy part of the car. Playback does not begin. [. . . ]