User manual SONY XBR-65HX929

[. . . ] 6, 816, 141 Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories. In the United States, TV Guide and TV Guide On Screen are registered trademarks of TV Guide Entertainment Group, Inc. and/or its subsidiaries or affiliates, and are used under a license by Gemstar-TV Guide International, Inc. [. . . ] The four function buttons (DVD, AMP, STB, and TV) blink when successfully reset. 5 Setting up your TV Some TV models are packaged with a detached Table-Top Stand so you can mount your TV to a wall right away. If you are not mounting the TV to a wall, you will need to attach the Table-Top Stand. You will need a Phillips screwdriver and the supplied screws to complete the task. Look for the supplied TableTop Stand instruction leaflet. Be sure to consider the following while setting up your TV: · Disconnect all cables when carrying the TV. · Carry the TV with the adequate number of people; larger size TVs require two or more people. · Correct hand placement while carrying the TV is very important for safety and to avoid damage. Attaching the Table-Top Stand Refer to the supplied Table-Top Stand instruction leaflet for proper attachment for some TV models. 1 Gently slide the TV unit onto the Table-Top Stand and align the screw holes. ~ · Do not put stress on the LCD panel or the frame around the screen. · Be careful to not pinch your hands or the AC power cord when you install the TV unit to the Table-Top Stand. 2 Use the supplied screws to attach the TV unit to the Table-Top Stand. For XBR-52/46HX909 For KDL-55/46/40HX800 · Ensure your TV has adequate ventilation, see page 15. · For best picture quality, do not expose the screen to direct illumination or sunlight. · Avoid installing the TV in a room with reflective wall and floor materials. · Avoid moving the TV from a cold area to a warm area. If you receive channels from a cable box or satellite receiver and do not wish to use the TV's built-in tuner, select Skip. Selecting Skip will disable the TV Guide On Screen feature, which is only available when the TV's tuner is used. ~ · If you skip the channel scan while in the setup menus, TV Guide will be disabled. 14 Using a Wall-Mount Bracket Your TV can be mounted on a wall using a Wall-Mount Bracket (not supplied) out of the box as packaged. If the Table-Top Stand is attached to the TV, the TV may require detaching the Table-Top Stand; see "Detaching the Table-Top Stand from the TV" (page 14). Prepare the TV for the Wall-Mount Bracket before making cable connections. For product protection and safety reasons, Sony strongly recommends that you use the Wall-Mount Bracket designed for your TV and the installation should be performed by a Sony dealer or licensed contractor. · Follow the instruction guide provided with the Wall-Mount Bracket for your model. Sufficient expertise is required in installing this TV, especially to determine the strength of the wall for withstanding the TV's weight. · Be sure to use the screws supplied with the Wall-mount bracket when attaching the mounting hooks to the TV set. The supplied screws are designed so that they are 8 mm to 12 mm in length when measured from the attaching surface of the mounting hook. The diameter and length of the screws differ depending on the Wall-mount bracket model. Use of screws other than those supplied may result in internal damage to the TV set or cause it to fall, etc. 8-12 mm Installing the TV Against a Wall or Enclosed Area Make sure that your TV has adequate ventilation. [. . . ] · Never use strong solvents such as a thinner, alcohol or benzine for cleaning. · Do not plug in the TV into the wall outlet until the moisture from cleaning has evaporated. The TV should also be placed on a stable surface to prevent it from toppling over (see page 12). If you have young children or pets at home, check regularly to insure the TV is securely fastened. Additional Information 19 Specifications System Television system NTSC: American TV standard ATSC (8VSB terrestrial): ATSC compliant 8VSB QAM on cable: ANSI/SCTE 07 2000 (Does not include CableCARD functionality) Analog terrestrial: 2 - 69 / Digital terrestrial: 2 - 69 Analog Cable: 1 - 135 / Digital Cable: 1 - 135 LCD (Liquid Crystal Display) Panel 10 W + 10 W 75-ohm external terminal for RF inputs VIDEO / AUDIO YPBPR (Component Video) / Signal format: 480i, 480p, 720p, 1080i, 1080p / AUDIO HDMI: Video: 480i, 480p, 720p, 720/24p, 1080i, 1080p, 1080/24p HDMI: Audio: Two channel linear PCM 32, 44. 1 and 48 kHz, 16, 20 and 24 bits, Dolby Digital AUDIO (HDMI IN 4) 500 mVrms (typical) PCM/Dolby Digital optical signal D-sub 15-pin, analog RGB Stereo mini jack 10BASE-T/100BASE-TX connector (Connection speed may differ depending on the network environment. 10BASE-T/100BASE-TX communication rate and communication quality are not guaranteed for this TV. )*1 Refer to the i-Manual for supported format. [. . . ]