User manual SONY XC-EI50

[. . . ] When you install the camera with various peripheral devices and if the devices have different ground electric potential, ground only one device. In case there is a ground electric potential difference, the camera may be damaged. 1 Power supply unit 3 Ground electric potencial difference 2 Abnormal electricity 4 Monitor To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Before operating the unit, please read this manual thoroughly and retain for future reference. Rear panel switches allow the following mode settings. HD (horizontal drive), VD (vertical drive) signals: The camera module automatically determines whether to operate in interlace or noninterlace mode from the HD and VD signals input for external synchronization. You can output the HD and VD signals from the 12-pin connector by changing the rear panel switch. Shutter speed can be selected from a wide range (1/125 to 1/10000 sec. The screw holes to install the camera module are located under the front panel (the CCD reference plane). The connector complies with the new EIAJ 12-pin assignment The new pin arrangement allows the connector to accept a trigger pulse and a WEN signal. 8 ft)/25N (25 m, 82 ft) camera cable This is attached to the DC IN/SYNC connector of the camera module and is used for power supply, transmission of video signals, and exchange of sync signals. 3 C-mount lens (For visible light) Recommended lens: VCL-08YM/12YM/16Y-M/25Y-M/50Y-M 4 DC-700/700CE camera adaptor This is connected to the camera module to enable power supply from ordinary AC power source, and also handles transmission of video signals from the camera module and exchange of sync signals between the camera module and an external sync signal generator. 5 VCT-333I tripod adaptor This attaches to the bottom of the camera module to fix the camera module to a tripod. 1 Lens mount (C-mount) Attach any C-mount lens or other optical equipment. Note The lens must not project more than 7 mm (9/32 inch) from the lens mount. 1 Lens mount face 2 7 mm (9/32 inch) or less 2 Reference holes (Top) 3 Reference holes/Tripod screw holes (bottom) 4 Reference holes (bottom) These precision screw holes are for locking the camera module. , see "About the Technical Manual" on the lower right of the back side. [. . . ] Use a tripod screw with a protrusion (4) extending from the installation surface, as follows: 4 ISO standard: Length 4. Note If you install a tripod adaptor (not supplied), use the screws provided. The Operating Instructions describe the functions and use of this product. [. . . ]