User manual SONY XC-ST50CE

[. . . ] When you install the camera with various peripheral devices and if the devices have different ground electric potential, ground only one device. In case there is a ground electric potential difference, the camera may be damaged. 1 Power supply unit 3 Ground electric potencial difference 2 Abnormal electricity 4 Monitor To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] HD (horizontal drive), VD (vertical drive) signals: The camera module automatically determines whether to operate in interlace or noninterlace mode from the HD and VD signals input for external synchronization. vS (Video/Sync) signals: External synchronization with a video or composite sync signal. (The unit switches automatically between HD/VD and VS synchronization. You can output the HD and VD signals from the 12-pin connector by changing the rear panel switch. Shutter speed can be selected from a wide range (1/125 to 1/10000 sec. These mounting screw holes are provided in the reference plane on the lower surface of the body, allowing mounting with the absolute minimum deviation of the optical axis. The connector complies with the new EIAJ 12-pin assignment The new pin arrangement allows the connector to accept a trigger pulse and a WEN signal. 8 ft)/25N (25 m, 82 ft) camera cable This is attached to the DC IN/SYNC connector of the camera module and is used for power supply, transmission of video signals, and exchange of sync signals. 3 C-mount lens Recommended lens: VCL-08YM/12YM/16Y-M/25Y-M/50Y-M 4 DC-700/700CE camera adaptor This is connected to the camera module to enable power supply from ordinary AC power source, and also handles transmission of video signals from the camera module and exchange of sync signals between the camera module and an external sync signal generator. 5 VCT-ST70I tripod adaptor This attaches to the bottom of the camera module to fix the camera module to a tripod. Use a tripod screw with a protrusion (4) extending from the installation surface, as follows: ISO standard: Length 4. Note If you install a tripod adaptor (not supplied), use the screws provided. 1 Lens mount (C-mount) Attach any C-mount lens or other optical equipment. The lens must not project more than 7 mm (9/32 inch) from the lens mount. [. . . ] This is related to the principle of CCD image sensors and is not a malfunction. The white flecks especially tend to be seen in the following cases: · When an extremely bright object, such as a strong spotlight or flashlight, is being shot, vertical tails may be produced on the screen, or the image may be distorted. Strong spotlight, strong reflected light, flashlight, the sun) When fine patterns, stripes, or lines are shot, they may appear jagged or flicker. [. . . ]