User manual SONY XDP-210EQ

[. . . ] The sound becomes unclear in some situations (such as when the BAS, TRE or EQ are excessively boosted). Two units can not be used at same time. Sound control mode can adjust not only BAS, TRE, BAL, FAD but also VOL. For further details, read the master unit instructions. [. . . ] Display window ALL Center of soundfield Normal setting (1 + 2 + 3) Front part (1 + 2) Right front (2) Note When you adjust the listening position, set the balance and fader control to the center position. Rotate/press (+) or (­) repeatedly until the desired listening position appears. The listening positions appear in the order shown above. Rotate/press (+) or (­) to adjust the center of the sound field to the left or right. After three seconds, the display goes back to the normal playback mode. Tip To adjust the listening position further, press (SOUND) for two seconds within three seconds after following step 2 above. Then go to step 4 to 8 of "Adjusting the listening position. Rotate/press (+) or (­) to adjust the center of the sound field to the front or rear. When the listening position setting is complete, the normal playback mode appears. You can adjust the subwoofer level independently of the speakers. To match the characteristics of the connected speakers or subwoofer(s), you can cut the unwanted high, middle and low frequency signals entering the speakers or subwoofer(s). By setting the cut-off frequency (see the diagram below), the speakers will output only the most suitable frequency signals so that you can get a clearer sound image. After three seconds, the display goes back to the normal playback mode. Tip To adjust the cut-off frequency of the subwoofer(s), press (SOUND) for two seconds within theree seconds after following step 3. -- Disc Sound Memory (DSM) (CD/MD changer or CD/MD player with program memory function) Once you have registered the desired equalizer curve and the sound characteristics (bass, treble and subwoofer level) onto the discs, you can enjoy the same equalizer curve every time you play them. Press (SHIFT), then press (3) (PLAY MODE) repeatedly until "DSM SET" appears. When the cut-off frequency setting is complete, the display goes back to the normal playback mode. Tip To adjust the subwoofer level, select "SUB" by pressing (1) (N) or (3) (n) after step 3 above. then rotate/press (+) or (­) to adjust the level. When you finish adjusting the subwoofer level, press (SOUND) for two seconds. [. . . ] Ground the lead securely to a metal part of the car. The power connecting leads are run too close to the RCA pin cords. The RCA pin cords are run too close to other electrical cables of the car. No sound The ground lead is not securely connected. [. . . ]