User manual SONY XDP-766EQ

[. . . ] You can adjust the 21 band frequencies to make an equalizer curve, and store up to nine curves. After three seconds, the display goes back to the normal playback mode. Tip To adjust the stored equalizer curve further, press (SOUND) for two seconds within three seconds after following step 3 above. Then go to step 4 to 8 of "Setting and storing the equalizer curve. [. . . ] Then go to step 2 to 7 of "Labeling an equalizer curve". Note If the name of the equalizer curve flashes in the display window, the equalizer curve is not stored. To store the equalizer curve again, repeat steps 6 to 9 above. Rotate/press (+) or (­) to select the number that you want to enter into memory. You can label each equalizer curve with a personalized name. You can enter up to eight characters for an equalizer curve. To return to the normal playback mode, press (SOUND) for two seconds. Tip To erase/correct a name, enter "_" (under-bar) for each character. Note When the name of the equalizer curve flashes in the display window, the equalizer curve name is not stored. To store the equalizer curve again, repeat the step 5 to 7 above rightly. You can set the time for the sound to reach the listeners from the speakers. Listening to each program source in its registered equalizer curve -- Source Sound Memory You can listen to the same source (CD, MD, TAPE, FM and AM) always in the same equalizer curve and sound characteristics (bass, treble and subwoofer level) even after changing the program source or turning the unit on and off again. Play the disc whose equalizer curve you want to change, and follow the "Setting and storing the equalizer curve". Press (SHIFT), then press (3) (PLAY MODE) repeatedly until "DSM SET" appears. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before switching on. If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. For safety reasons, keep your car audio volume moderate so that you can still hear sounds outside your car. If you connect this unit to the XDP-U50D, this unit will not work. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. If the fuse blows again after replacement, there may be an internal malfunction. Warning When replacing the fuse, be sure to use one matching the amperage stated above the fuse holder. [. . . ] The following check help you remedy most problems that you may encounter with you unit. Before going through the checklist below, check the connection and operating procedures. problem The POWER indicator does not light up. Cause/Solution The ground lead is not securely connected. [. . . ]