User manual SONY XDR-S1

[. . . ] RESET button Press this button with a pointed object when the radio fails to function properly. To wall outlet AC power cord Displays the service label and COMPONENT the component label you are LABEL DISPLAY listening to. "AM 12:00" will blink in the display when the AC power cord is plugged in for the first time. DAB Search makes it easy to create a preset list of receivable DAB broadcasts. [. . . ] notes · This function works only when receiving RDS data. ⷠIf it may not operate depending on the areas, disable this function. ⷠIf this function is being activated while adjusting the clock manually, RDS data will adjust the clock the next time the unit receives it. Note Adjust the direction of the antenna by holding the bottom of it. The antenna can be damaged when you move the antenna with excessive force. a) Connect the AC power cord (supplied) to the AC IN jack of the unit and plug it in to a wall outlet. Note If the AC power cord is disconnected for more than 5 minutes, the settings for the clock, standby timers, any lists of receivable broadcasts for DAB search and preset station memory will be initialized. You can preset 10 services in DAB and 10 stations each for FM, MW and LW. This function indicates services or RDS data in each programme type, such as NEWS, SPORTS of the PTY list, transmitted in the DAB or RDS data. To display the programme type of the service or station being received Press DISPLAY/CANCEL a few times. ) If the received service or station does not transmit the programme type, "NO PTY" appears. The name of the station (a maximum of 8 characters available) appears in the upper line indication area and the frequency appears in the lower line indication area. You can enjoy falling asleep to the radio using the built-in sleep timer that turns off the radio automatically after a preset duration. To record with the optical digital out Should any problem persist after you have made the following checks, consult your nearest Sony dealer. The unit is being used in extremely high or low temperatures or in a place with excessive moisture. Very weak or interrupted sound, or unsatisfactory reception. ⷠIn a building, listen near a window. A station or service cannot be received when a PRESET TUNING button is pressed. Please keep a copy of your settings in case you want to preset them again. And then "SC" appears while receiving the secondary component. Hold down the PRESET TUNING buttons you wish to preset for more than 2 second. You will hear two short beeps and the preset number will appear in the display. [. . . ] Scanning starts from the frequency being tuned in. When a station is received, scanning pauses for 3 seconds and then continues. To change the display mode, press DISPLAY/CANCEL while the unit is on. Each band has two lines indication areas in the display. [. . . ]