User manual SONY XES-Z50

[. . . ] Before operating the unit, please read this manual thoroughly and retain it for future reference. Owner's Record The model and serial numbers are located at the rear of the CD changer and the bottom of the control unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. [. . . ] Note You cannot use the Bank function for discs that have not been labeled using the Disc Memo function. Mode " Repeat Set up off Shuffle Name off Bank AUX Disc Sound Memory Exit Mode" and press / to move to the sub menu, then select "Bank" using > or . Mode " Repeat Set up Shuffle Name Bank AUX Disc Sound Memory Exit off off off" on inverse off edit To move to the next track, press the / button. Note that only tracks 1 to 24 on a disc can be set. You can select and memorize particular sound effects for up to 110 discs (CDs or MDs). Note To use this function, select the sound effect in advance (see page 51). Mode " Repeat Set up off Shuffle Name off Bank AUX Disc Sound Memory Exit Mode" and press / to move to the sub menu, then select "Disc Sound Memory" using > or . Mode " Repeat Set up Shuffle Name Bank AUX Disc Sound Memory Exit off off off " enter delete The sound effects currently specified by PEQ display are set. To clear all sound effects on the disc Select "delete" in Step 3 above and press the ENTER button. You can record a title of up to 8 characters for each disc. The disc title appears in the display whenever you insert the disc and play it. Useful tips Hold down the LIST button for 2 seconds or more to display the Disc Memo Write indication directly. Select "Name" and press / to move to the sub menu, then select "Disc Memo" using > or . Until the character you want to enter appears, then press /. Each press of the > button selects the next character in the order shown below. Repeat Step 4 until you have entered the entire title, then press ENTER. Select "Name" and press / to move to the sub menu, then select "Disc Memo" using > or . Or / until the frequency you want appears in the display, then release the button. Note If you selected AM in Step 1, "Mono/Stereo" and "Antenna" sub menu will not appear in the display. Mode"and press / to move to the sub menu, then select "Preset" using > or . Note If you set a new frequency to a preset station number that has already been assigned a frequency, the new frequency replaces the old frequency. To select the preset station number to which the frequency will be stored (the selected preset station number is highlighted), then press ENTER. [. . . ] If the remote becomes inoperative, replace the batteries, then verify that it can operate the system. If the red indicator no longer flashes when you press an operation button on the remote, it means the batteries are weak. The following checklist will help you remedy most problems you may encounter with your system. before going through the checklist , check the connections and the operating procedures. [. . . ]