User manual SONY XL-2400

[. . . ] If used in USA, use the UL LISTED power cord specified below. Plug Cap Parallel blade with ground pin (NEMA 5-15P Configuration) Cord Type SJT, three 16 or 18 AWG wires Length Minimum 1. ) Rating Minimum 10 A, 125 V Using this unit at a voltage other than 120V may require the use of a different line cord or attachment plug, or both. 1 Use the approved Power Cord (3-core mains lead) / Appliance Connector / Plug with earthing-contacts that conforms to the safety regulations of each country if applicable. [. . . ] (This process may differ in other countries. ) Once your identity has been confirmed, we will provide you with the password. To turn off the power " appears to confirm that you want to turn off the power. A message disappears if you press any key except the I / 1 key, or if you do not press any key for five seconds. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce the internal heat. Also, the ON/STANDBY indicator flashes quickly for the first 60 seconds. During this time, you will not be able to light up the ON/STANDBY indicator with the I / 1 key. Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red. When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / 1 key for about one second. The internal circuitry of the Direct Power On/Off function may cause the fan to continue to operate for a short time even after the I / 1 key is pressed to turn off the power and the ON/STANDBY indicator changes to red. If you will be using a circuit breaker to turn the power for the entire system on and off, set the direct power on function to "On". Use the M or m key to select the item, then press the , or ENTER key. You can hide this indicator using "Status" in the MENU SETTING menu. When changing the adjustment level: To increase the number, press the M or , key. When changing the setting: Press the M or m key to change the setting. The PICTURE SETTING menu is used for adjusting the picture or volume. Items that cannot be adjusted depending on the input signal are not displayed in the menu. The menu disappears automatically if a key is not pressed for one minute. " appears on the screen and the settings appearing on the screen are reset to their factory preset values. If the picture has roughness with the "Dynamic" setting, this setting reduces the roughness. About the memory of the settings The unit can store the setting values of the following sub menu items for each "Dynamic" or "Standard" picture mode separately. If there is no input signal, "Cannot adjust this item. [. . . ] Monaural sound is being input through the AUDIO connector. through AUDIO connector , c Input stereo sound. C Replace with a new battery (see page 15). Press the MENU key on the c Set the PJ/NETWORK select switch to PJ, then press the Remote Commander. [. . . ]