Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SONY XM-250X. We hope that this SONY XM-250X user guide will be useful to you.
Lastmanuals help download the user guide SONY XM-250X.
Detailed instructions for use are in the User's Guide.
[. . . ] â· Use speakers with an impedance of 2 to 8 ohms (4 to 8 ohms when used as a bridging amplifier). â· Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. [. . . ] The ground lead is not securely connected. n Fasten the ground lead securely to a metal point of the car. The voltage going into the remote terminal is too low. â· The connected master unit is not turned on. The power connecting leads are installed too close to the RCA pin cords. The ground lead is not securely connected. Mount the unit either inside the trunk or under a seat. â· Choose the mounting location carefully so the unit will not interfere with the normal movements of the driver and it will not be exposed to direct sunlight or hot air from the heater. â· Do not install the unit under the floor carpet, where the heat dissipation from the unit will be considerably impaired. First, place the unit in the location you plan to install it, and mark the positions of the four screw holes on the mounting board (not supplied). Then drill a 3 mm pilot hole at each mark and mount the unit onto the board with the supplied mounting screws. The mounting screws are all 15 mm long, so make sure that the mounting board is thicker than 15 mm. Before making any connections, disconnect the ground terminal of the car battery to avoid short circuits. â· Be sure to use speakers with an adequate power rating. If you use small capacity speakers, they may be damaged. â· Do not connect the ' terminal of the speaker system to the car chassis, and do not connect the ' terminal of the right speaker with that of the left speaker. [. . . ] When using passive crossover networks in a multi-speaker system, care must be taken as the speaker system's impedance should not be lower than that of the suitable impedance for this unit. â· When you are installing a 12 decibels/octave system in your car, the following points must be considered. In a 12 decibels/octave system where both a choke and capacitor are used in series to form a circuit, great care must be taken when they are connected. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SONY XM-250X
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SONY XM-250X will begin.
