Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SONY XM-440NX. We hope that this SONY XM-440NX user guide will be useful to you.
Lastmanuals help download the user guide SONY XM-440NX.
Detailed instructions for use are in the User's Guide.
[. . . ] Use speakers with suitable impedance (2 to 8 ohms). Make sure to place the unit in a well ventilated location. The power connecting leads are installed too close to the RCA pin cords. The ground lead is not securely connected. [. . . ] First, place the unit where you plan to install it, and mark the positions of the four screw holes on the surface of the mounting board (not supplied). Then drill the holes approximately 3 millimeters (mm) in diameter and mount the unit onto the board with the supplied mounting screws. the supplied mounting screws are 15 mm long. Therefore, make sure that the mounting board is thicker than 15 mm. This unit is designed for negative ground 12 V DC operation only. Use speakers with suitable impedance (2 8 ohms). Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Avoid installing the unit in areas subject to: -- high temperatures such as from direct sunlight or hot air from the heater -- rain or moisture -- dust or dirt. If your car is parked in direct sunlight and there is a considerable rise in temperature inside the car, allow the unit to cool down before use. When installing the unit horizontally, be sure not to cover the fins with the floor carpet, etc. If this unit is placed too close to the car radio, interference may occur. In this case, relocate the amplifier away from the car radio. If no power is being supplied to the master unit, check the connections. This power amplifier employs a protection circuit* to protect the transistors and speakers if the amplifier malfunctions. Do not attempt to test the protection circuits by covering the heat sink or connecting improper loads. Do not use the unit on a weak battery as its optimum performance depends on a good power supply. For safety reasons, keep your car audio volume moderate so that you can still hear sounds outside your car. [. . . ] Be sure to connect the remote control lead of the car audio to the remote terminal. When using a car audio without a remote output on the amplifier, connect the remote input terminal (REMOTE) to the accessory power supply. Use the power supply lead with a fuse attached (30 A). Place the fuse in the power supply lead as close as possible to the car battery. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SONY XM-440NX
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SONY XM-440NX will begin.
