User manual SONY XM-5040X

[. . . ] Accessories Supplied accessories Mounting screws (4), High level input cord (2), Protect cover (1), Protection cap (1) Design and specifications are subject to change without notice. This unit can be used as a monaural amplifier with a maximum output of 260 watts. Direct connection can be made with the speaker output of your car audio if it is not equipped with a line output (High level input connection). Low-pass filter, high-pass filter and low boost circuit, separated for both the left and right sides. [. . . ] Doing so may damage the active speakers. Avoid installing the unit where: -- it would be subject to high temperatures such as from direct sunlight or hot air from the heater -- it would be exposed to rain or moisture -- it would be subject to dust or dirt. If your car is parked in direct sunlight and there is a considerable rise in temperature inside the car, allow the unit to cool down before use. When installing the unit horizontally, be sure not to cover the fins with the floor carpet etc. If this unit is placed too close to the car radio, interference may occur. In this case, relocate the amplifier away from the car radio. If no power is being supplied to the master unit, check the connections. This power amplifier employs a protection circuit* to protect the transistors and speakers if the amplifier malfunctions. Do not attempt to test the protection circuits by covering the heat sink or connecting improper loads. Do not use the unit on a weak battery as its optimum performance depends on a good power supply. For safety reasons, keep your car audio volume moderate so that you can still hear sounds outside your car. Before making any connections, disconnect the ground terminal of the car battery to avoid short circuits. Be sure to use speakers with an adequate power rating. If you use small capacity speakers, they may be damaged. Do not connect the # terminal of the speaker system to the car chassis, and do not connect the # terminal of the right speaker with that of the left speaker. Install the input and output cords away from the power supply lead as running them close together can generate some interference noise. Therefore, it may not perform to its full potential if used with the speaker cords supplied with the car. If your car is equipped with a computer system for navigation or some other purpose, do not remove the ground wire from the car battery. [. . . ] A loose connection may cause a malfunction of the amplifier. Be sure to connect the remote control lead of the car audio to the remote terminal. When using a car audio without a remote output on the amplifier, connect the remote input terminal (REMOTE) to the accessory power supply. Use the power supply lead with a fuse attached (40 A). [. . . ]