User manual SONY XM-GTX6020

[. . . ] Make sure the speaker cord and ground wire are securely connected. Design and specifications are subject to change without notice. Halogenated flame retardants are not used in cabinets. Halogenated flame retardants are not used in printed wiring boards. [. . . ] * Protectioncircuit This amplifier is provided with a protection circuit that operates in the following cases: -- when the unit is overheated -- when a DC current is generated -- when the speaker terminals are short-circuited. The colour of the POWER/PROTECTOR indicator will change from green to red, and the unit will shut down. If this happens, turn off the connected equipment, take out the cassette tape or disc, and determine the cause of the malfunction. If the amplifier has overheated, wait until the unit cools down before use. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. If the fuse blows again after replacement, there may be an internal malfunction. in such a case , consult your nearest Sony dealer. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Notice for customers: the following information is only applicable to equipment sold in countries applying EU directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan, Minato-ku, Tokyo, Japan. the Authorized Representative for EMC and product safety is Sony Deutschland GmbH , Hedelfinger Strasse 61 , 70327 Stuttgart , Germany. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. Turn on or off the LPF switch at the unit rear as illustrated below. Pass the wires through the cap, connect the wires, then cover the terminals with the cap. Mount the unit either inside the trunk or under a seat. Choose the mounting location carefully so the unit will not interfere with the normal movements of the driver and it will not be exposed to direct sunlight or hot air from the heater. Do not install the unit under the floor carpet, where the heat dissipation from the unit will be considerably impaired. First, place the unit where you plan to install it, and mark the positions of the 4 screw holes on the mounting board (not supplied). Then drill a 3 mm pilot hole at each mark and mount the unit onto the board with the supplied mounting screws. [. . . ] Be sure to connect the remote control wire of the car audio unit to the remote terminal. When using a car audio unit without a remote output on the amplifier, connect the remote input terminal (REMOTE) to the accessory power supply. Use a power supply wire with a fuse attached (30 A). All power wires connected to the positive battery post should be fused within 450 mm of the battery post, and before they pass through any metal. [. . . ]