User manual SONY XM-ZR604R

[. . . ] AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION 60 watts per channel minimum continuous average power into 4 ohms, both channels driven from 20 Hz to 20 kHz with no more than 1 % total harmonic distortion per Car Audio Ad Hoc Committee standards. other Specifications OTL (output transformerless) circuit Pulse power supply Inputs RCA pin jacks High level input connector Input level adjustment range 0. 8 ­ 12 V (High level input) Outputs Speaker terminals Speaker impedance 2 ­ 8 (stereo) 4 ­ 8 (when used as a bridging amplifier) Maximum output 4 Speakers: 110 W × 4 (at 4 ) 3 Speakers: 150 W × 2 (at 2 ) + 300 W × 1 (BTL, at 4 ) Rated output (supply voltage at 14. Halogenated flame retardants are not used in cabinets. [. . . ] Hi-level Sensing Power On feature allows unit to be activated without need for REMOTE connection. Direct connection can be made with the speaker output of your car audio unit if it is not equipped with the line output (High level input connection). * Pulse power supply This unit has a built-in power regulator which converts the power supplied by the 12 V DC car battery into high speed pulses using a semiconductor switch. These pulses are stepped up by the built-in pulse transformer and separated into both positive and negative power supplies before being converted into direct current again. This is to regulate fluctuating voltage from the car battery. This light weight power supply system provides a highly efficient power supply with a low impedance output. * Protection circuit This amplifier is provided with a protection circuit that operates in the following cases: -- when the unit is overheated -- when a DC current is generated -- when the speaker terminals are short-circuited. The color of the POWER/PROTECTOR indicator will change from green to red, and the unit will shut down. If this happens, turn off the connected equipment, take out the cassette tape or disc, and determine the cause of the malfunction. If the amplifier has overheated, wait until the unit cools down before use. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. If the fuse blows, check the power connection and replace both the fuses. If the fuse blows again after replacement, there may be an internal malfunction. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. the recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. Turn on or off the LPF and HPF switch at the unit rear as illustrated below. [. . . ] A loose connection may cause a malfunction of the amplifier. Be sure to connect the remote control wire of the car audio unit to the remote terminal. When using a car audio unit without a remote output on the amplifier, connect the remote input terminal (REMOTE) to the accessory power supply. Use a power supply wire with a fuse attached (50 A). [. . . ]