User manual SONY XM-CU150

[. . . ] Halogenated flame retardants are not used in printed wiring boards. Accessories Supplied accessories Mounting screws (4) High level input cord (1) Protection cap (1) Harmonic distortion Low-pass filter High-pass filter Power requirements Design and specifications are subject to change without notice. Make sure the speaker cord and ground wire are securely connected. Make sure to place the unit in a well ventilated location. [. . . ] If your car is parked in direct sunlight and there is a considerable rise in temperature inside the car, allow the unit to cool down before use. When installing the unit horizontally, be sure not to cover the fins with the floor carpet etc. If this unit is placed too close to the car audio unit or antenna, interference may occur. In this case, relocate the amplifier away from the car audio unit or antenna. If no power is being supplied to the car audio unit, check the connections. This power amplifier employs a protection circuit* to protect the transistors and speakers if the amplifier malfunctions. Do not attempt to test the protection circuits by covering the heat sink or connecting improper loads. Do not use the unit on a weak battery as its optimum performance depends on a good power supply. For safety reasons, keep your car audio unit volume moderate so that you can still hear sounds outside your car. When replacing the fuse, be sure to use one matching the amperage stated above the fuse holder. Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Note When you tighten the screw, be careful not to apply too much torque* as doing so may damage the screw. * The torque value should be less than 1 N· Mount the unit either inside the trunk or under a seat. Choose the mounting location carefully so the unit will not interfere with the normal movements of the driver and it will not be exposed to direct sunlight or hot air from the heater. Do not install the unit under the floor carpet, where the heat dissipation from the unit will be considerably impaired. First, place the unit where you plan to install it, and mark the positions of the 4 screw holes on the mounting board (not supplied). Then drill a 3 mm (1/8 in) pilot hole at each mark and mount the unit onto the board with the supplied mounting screws. The mounting screws are all 15 mm (19/32 in) long, so make sure that the mounting board is thicker than 15 mm (19/32 in). Front right speaker output Salida del altavoz delantero derecho Saída do alto-falante dianteiro direito Grey Gris Cinza Striped Con rayas Com Listra White Blanco Branco Striped Con rayas Com Listra Front left speaker output Salida del altavoz delantero izquierdo Saída do alto-falante frontal esquerdo Remote output*1 Salida remota*1 Saída remota*1 (REM) Car audio unit Sistema de audio para automóvil Rádio automotivo less than 450 mm (18 in) menos de 450 mm menos de 450 mm In this system, the volume of the subwoofer will be controlled by the car audio unit fader control. In this system, the output signals to the subwoofer will be the combination of both the REAR L and R INPUT jacks or the REAR high level input connector signals. *1 If you have the factory original or some other car audio unit without a remote output for the amplifier, connect the remote input terminal (REMOTE) to the accessory power supply. In High level input connection, car audio unit can also be activated without need for REMOTE connection. [. . . ] If you disconnect the wire, the computer memory may be erased. To avoid short circuits when making connections, disconnect the +12 V power supply wire until all the other wires have been connected. Connect the +12 V power supply wire only after all the other wires have been connected. Be sure to connect the ground wire of the unit securely to a metal point of the car. [. . . ]