User manual SONY XPEV501R

[. . . ] · This CD player can play CD-Rs/CD-RWs recorded in the Compact Disc Digital Audio (Audio CD) format, but playback capability may vary depending on the quality of the disc and the condition of the recording device. · This product is designed to play back discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. [. . . ] Press to enter the selected track for the PGM play. 5 s(stop)/OFF/ CHARGE(s) 6 HOLD Press to stop playing. Use to lock the controls on your CD player or remote control to prevent accidental button presses. HOLD on the CD player works only for the player, while HOLD on the remote control works only for the remote control. Press (slide for the remote control) to adjust the volume. Set to ON to protect against sound skipping. *3 Display Sound mode Play mode Remote control (XP-EV501R only) 4ca 7VOL 3tF SKIP To insert the batteries 1 Open the battery compartment lid on the rear of your CD player. 2 Insert two batteries by matching the ) to the diagram 2SOUND in the battery compartment and close the lid until it clicks into place. 7 VOL+/­ 8 E·A·S·S*2 3 When using the rechargeable batteries, connect AC CHG Track number Playing time 6HOLD Remaining battery power Headphones jack 5s 3rB SKIP power adaptor (not supplied) to the DC IN 4. 5V jack of your CD player and an AC outlet, then press s/ OFF/CHARGE to start charging. The "CHG" indicator turns on in the display and the indicator sections of light up in succession. When the batteries are completely charged, the "CHG" and indicators get turned off. If you press s/OFF/CHARGE after the charge has indicator flashes already been completed, the and "Full" appears in the display. Note Use only the supplied remote control. You cannot operate this CD player with the remote control supplied with other CD players. *1 If the sound is distorted when using the SOUND function, turn down the volume. *2 E·A·S·S = Electronic Anti-Shock System *3 Sound may skip: ­ if the CD player receives stronger continuous shock than expected, ­ if a dirty or scratched CD is played or ­ when using poor-quality CD-Rs/CD-RWs or if there is a problem with the recording device or application software. 4 Disconnect the AC power adaptor. hours) (When the CD player is used on a flat and stable place. ) Playing time varies depending on how the CD player is used. To remove the CD Remove the CD while pressing the pivot (E). (Continue to the reverse side) C to an AC outlet DC IN 4. 5 V AC power adaptor (not supplied) D Label side up E·A·S·S ON Two Sony alkaline batteries LR6 (SG) (produced in Japan) 50 OFF 40 \ E * Measured value by the standard of JEITA (Japan Electronics and Information Technology Industries Association). To check the remaining power of the batteries You can check it in the display. Replace the batteries when " Lo batt* " flashes. Headphones * Beep sounds only when the CD player is set to sounds beep. See "To turn off the operation beep sound" on the reverse side. To turn off the operation beep sound You can turn off the beep sound that is heard from your headphones when you operate your CD player. 1 Remove the power source (AC power adaptor, rechargeable batteries or dry batteries) from the CD player. · Do not touch the AC power adaptor with wet hands. [. . . ] When to replace the rechargeable batteries If the battery life becomes shorter by about half, replace the batteries with new rechargeable batteries. Maintenance To clean the casing Use a soft cloth slightly moistened in water or a mild detergent solution. Do not use alcohol, benzine or thinner. Mass (excluding accessories) Approx. 175 g (6 oz) 2 Press r or t to select a track. [. . . ]