User manual SONY XPR100

[. . . ] · Make sure that pins or other foreign object do not get inside the player. · Take care not to drop the unit or subject it to strong shocks. · To keep dust from the pickup lens, keep the disc compartment lid closed after use. · If you hear no sound when playing a disc, DO NOT turn the volume up high because music could suddenly start at high volume. [. . . ] When charging is completed, "C-OFF" flashes a few times, and the battery indicator goes out. After charging, disconnect the AC adaptor. 3 Time to recharge the batteries Recharge the batteries when lights. If the unit remains in use after lights, "Lo-bAtt" appears and the current operation stops. To stop charging F Press sSTOP/OFF/CHARGE during charging. Force charging When the recharging stops after only few minutes or the batteries cannot be fully recharged, press sSTOP/OFF/CHARGE while pressing PLAY MODE to start force charging. ATTENTION: The product you have purchased can be powered by nickel cadmium batteries which are recyclable. At the end of their useful life, under various state and local laws, it is illegal to dispose of these batteries into your municipal waste stream. Please call 1-800-289-2492 for information on how to recycle these batteries. G DSL USING ON AC HOUSE CURRENT Use only an AC adaptor whose rated output is DC 5 ­ 6 V, 250 ­ 300 mA. Connect the AC adaptor in the same way as when recharging the batteries. During operation on AC house current, all of the battery indicator disappears. BEFORE PLAYBACK HOLD switch F Release the HOLD switch before playback. a When not using the unit, set the HOLD switch to the HOLD position. b Accidentally pressed button will not function. If buttons are pressed when the HOLD switch is set to the HOLD position, "HOLd" flashes in the display. Turning on and off F H1 Turning the power on Press ePLAY/PAUSE. Power is turned on and playback starts. Note "Err" appears on the display when you play a disc placed upside-down or a defective disc. Turning the power off If no new operations are done within 30 seconds from the end of last operation, the power is turned off automatically. . To cancel random play, press PLAY MODE while in standby mode. display changes to . Note · You cannot back to previous track by pressing r during random play. · You cannot select one-track repeat during random play. M PLAY MODE Repeat play M Press PLAY MODE during playback to select repeat play as follows. : one-track repeat B V : all-track repeat V no repeat play (normal play) completely (ideally about 20 seconds). Continuous shock or vibration may cause the sound to be interrupted even if the E·A·S·S 2× function is activated. Should you experience an interruption in sound, stabilize the unit for a few seconds, then resume your activity. · When the E·A·S·S 2× function is activated, motor noise is heard as the motor periodically rotates at high speed during playback. · When the E·A·S·S switch is slid during playback, the unit will pause for about 2 seconds. · When you set the E·A·S·S switch to the OFF position, the quality of the sound will be better than the case that you set it to the ON position. Resume function M L Set the HOLD switch to RESUME. appears, and you can start playback from the point where you stopped playback by pressing sSTOP/OFF/CHARGE. When the resume function is on, all-track repeat is selected automatically. [. . . ] 2 While "S-10" is displayed, press PRESET CALL UP/DOWN to display "S-9". To resume to 10 kHz, change in the similar way. P FM AM Note Q When the AM step is changed, stations that you preset are erased. PRESETTING STATIONS R You can preset up to total of 30 stations on AM and FM. 1 Press BAND TUNER ON repeatedly to select AM or FM. 2 Press TUNING + (t) or - (r) to tune in to a station. [. . . ]