User manual SONY XR-1800

[. . . ] ATA (Automatic Tuner Activation) for automatically turning on the tuner while fastforwarding or rewinding a tape (page 6). Automatic Memory function stores a total of 18 stations in memory quickly and easily (page 7). Do not touch the tape surface of a cassette, as any dirt or dust will contaminate the heads. [. . . ] Do not press hard or give excessive pressure to the display windows of the front panel. Before removing the front panel, be sure to turn the power off. However, if you press the RELEASE button to detach the panel while the unit is still turned on, the power will be automatically turned off in order to protect the speakers from being damaged. Do not expose the front panel to direct sunlight, heat sources such as hot air ducts or leave it in a humid place. Of a car parked in direct sunlight where there may be a considerable rise in temperature inside the car. Button for more than two The side facing down is being played. Note Before turning off the unit, eject the tape to avoid tape damage. Note The clock cannot be set unless the power is turned on. Set the clock after you turn on the radio, or during tape playback. To resume playback, press the other fastwinding button partially until the locked button is released. Press either side of the SEEK/MANU button momentarily to search for the next station (automatic tuning). Press either side of the button repeatedly until the desired station is received. When an FM stereo program with a sufficient signal strength is tuned in, When fast-forwarding or rewinding with the 0 or ) button, the tuner will turn on automatically. To avoid the automatic tuning from stopping on stations too frequently (local seek mode), press the LCL button momentarily to get the "LCL" indication. Only the stations with relatively strong signals will be tuned in. Release the button when the desired station is received. Tune in the station which you wish to store on the preset number button. Press and hold the desired preset number button ( 1 to 6 ) for about two seconds until you hear a beep tone. [. . . ] Otherwise, the connector may get damaged. To reactivate the beep tone, press these buttons once more. Back of the front panel 1 Display window 2 SEL (control mode select) button 58 3 DSPL (display mode change/time set) button 5 4 6 (eject) button 5 5 During radio reception: Preset number buttons 7 During tape playback: ATA (Automatic Tuner 1 Activation) button 6 6 0/) (fast winding)/DIR (tape transport direction change) buttons 56 7 LCL (local seek) button6 Tape track Wow and flutter Frequency response Signal-to- noise ratio 4-track 2-channel stereo 0. [. . . ]