User manual SONY XR-3208MK2

[. . . ] Automatic Memory function stores a total of 30 stations in memory quickly and easily (page 7). Do not touch the tape surface of a cassette, as any dirt or dust will contaminate the heads. Keep cassettes away from equipment with built-in magnets such as speakers and amplifiers, as erasure or distortion of the recorded tape could occur. [. . . ] Do not press the front panel hard against the unit when attaching it to the unit. It can easily be attached by pressing it lightly against the unit. When you carry the front panel with you, put it in the supplied front panel case. Do not press hard or give excessive pressure to the display windows of the front panel. Before removing the front panel, be sure to turn the power off. However, if you press the RELEASE button to detach the panel while the unit is still turned on, the power will be automatically turned off in order to protect the speakers from being damaged. Button for more than two The side facing down is being played. Note Before turning off the unit, eject the tape to avoid tape damage. Note The clock cannot be set unless the power is turned on. Set the clock after you turn on the radio, or during tape playback. To resume playback, press the other fastwinding button partially until the locked button is released. Press either side of the SEEK/MANU button momentarily to search for the next station (automatic tuning). For lower frequencies For higher frequencies Press either side of the button repeatedly until the desired station is received. When an FM stereo program with a sufficient signal strength is tuned in, To avoid the automatic tuning from stopping on stations too frequently (local seek mode), press the SENS button momentarily to get the "LCL" indication. Only the stations with relatively strong signals will be tuned in. The sound will improve, but it will become monaural. [. . . ] Adjust within three seconds after selecting. (After three seconds the button will again serve as volume control button. Back of the front panel To reactivate the beep tone, press these buttons once more. [. . . ]