User manual SONY XR-3300

[. . . ] If your car is parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. If no sound comes from the speakers of a 2-speaker system, set the fader control to the center position. [. . . ] Press either side of the button repeatedly until the desired station is received. When an FM stereo program with a sufficient signal strength is tuned in, Release the button when the desired station is received. When tuning in during driving, use the automatic tuning and the memory preset tuning instead of the manual tuning. Tune in the station which you wish to store on the preset number button. Press and hold the desired preset number button ( 1 to 6 ) for about two seconds until you hear a beep tone. This function selects from the currently received band the stations with the strongest signals and memorizes them in order of their frequency. The number of the pressed preset number button appears in the display window. Up to 6 stations on each band (FM1, FM2 and FM3) can be stored on the preset number buttons in the order of your choice. Therefore, 18 stations can be memorized on FM. If you try to store another station on the same preset number button, the previously stored station will be erased. Press the button for more than two seconds. ) The unit is factory preset to "REG ON, " but if you want to turn off the function, do the following. Press the button for more than two seconds until "REG OFF" lights up in the display. Note that selecting "REG OFF" might cause the unit to switch to another regional station within the same network. Note This function does not work in the United Kingdom and in some other areas. Tip When the traffic announcement starts while you are listening to another programme source, the unit automatically switches to the announcement and goes back to the original source when the announcement is over. notes · "NO TP" flashes for five seconds if the received station doesn't broadcast traffic announcements. Then, the unit starts searching for a station that does broadcast traffic announcements. When the "EON" indication appears with "TP" in the display window, the current station makes use of broadcast traffic announcements of other stations in the same network. To cancel all traffic announcements, turn off the function by pressing the AF/TA button until "AF/TA OFF" lights up. The Local Link function lets you select other local stations in the area, even though they are not stored in your presets. You can preset the volume level of the traffic announcements beforehand so you wouldn't miss the announcement. [. . . ] Repeat from step 1 for presetting other stations. Note You cannot use this function in some countries where no PTY (Programme Type selection) data is available. Press the button during FM reception until "PTY" lights up in the display. "- - - - -" appears if the received station is not an RDS station or if the RDS data has not been received. [. . . ]