User manual SONY XR-3304

[. . . ] If you have drink holders near your audio equipment, be careful not to splash juice or other soft drinks onto the car audio. Sugary residues on this unit or cassette tapes may contaminate the playback heads, reduce the sound quality, or prevent sound reproduction altogether. Cassette cleaning kits cannot remove sugar from the tape heads. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. [. . . ] RDS may not work properly if the signal strength is weak or if the station you are tuned to is not transmitting RDS data. To return to normal mode, select "MONOOFF" in step 2 above. Each time you press (DSPL), the item changes as follows: After you select the desired item, the display will automatically change to the Motion Display mode after a few seconds. In the Motion Display mode, all the above items are scrolled in the display one by one in order. Tip The Motion Display mode can be turned off. Note The "*" indication means that an RDS station is being received. Each time you press (DSPL), the item changes as follows: After you select the desired item, the display will automatically change to the Motion Display mode after a few seconds. In the Motion Display mode, all the above items are scrolled in the display one by one in order. Tip The Motion Display mode can be turned off. (See "Changing the sound and display settings" on page 19). Note "NO NAME" appears if the received station does not transmit RDS data. notes · "NO TP" flashes for five seconds if the received station does not broadcast traffic announcements. Then, the unit starts searching for a station that broadcasts it. When "EON" appears with "TP" in the display, the current station makes use of broadcast traffic announcements by other stations in the same network. Within five seconds, press the number button of the local station again. Repeat this procedure until the desired local station is received. To cancel all traffic announcements, turn off the function by pressing (AF/TA) until "AF TA-OFF" appears. You can preset the volume level of the traffic announcements beforehand so you won't miss the announcement. When a traffic announcement starts, the volume will be automatically adjusted to the preset level. When you preset RDS stations, the unit stores each station's data as well as its frequency, so you don't have to turn on the AF or TA function every time you tune in the preset station. You can select a different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. If an emergency announcement comes in while you are listening to the radio, the programme will automatically switch to it. [. . . ] Never touch the connectors directly with your fingers or any metal device. Outputs Audio output (XR-C33R only) Power aerial relay control lead Power amplifier control lead (XR-C33R only) Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative earth) Approx. 2 kg Parts for installation and connections (1 set) Front panel case (1) Rotary commander RM-X4S BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) (XR-C33R only) CD changer (10 discs) CDX-828, CDX-737 MD changer (6 discs) MDX-65 Other CD/MD units with the Sony-BUS system Source selector XA-C30 Design and specifications are subject to change without notice. The following checklist will help you remedy the problems you may encounter with your unit. [. . . ]