User manual SONY XR-4800

[. . . ] Of a car parked in direct sunlight where there may be a considerable rise in temperature inside the car. If you turn the ignition key to the OFF position without removing the front panel, the caution alarm will beep for a few seconds (only when the POWER SELECT switch is set to the A position). Press (RELEASE) to detach the front panel then gently pull it out. Be sure not to drop the panel when detaching it from the unit. [. . . ] scanning stops when a station is received. Press either side of (SEEK/AMS) repeatedly until the desired station is received. Note If the automatic tuning stops too frequently, press (LCL) to light up "LCL" on the display (local seek mode). Only the stations with relatively strong signals are tuned in. Tip If you know the frequency, press and hold either side of (SEEK/AMS) until the desired station is received (manual tuning). Adjust within three seconds after selecting. (After three seconds the button will again serve as the volume control button. To enjoy clear and powerful bass sound, you can boost only the low frequency signal with a sharp curve. This is the effect you get when use an optional subwoofer system. For example, you can hear the bass line more clearly even if the vocal volume remains the same. You can emphasize and adjust the bass sound easily with the D-BASS control. If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. If no sound comes from the speakers of a 2-speaker system, set the fader control to the center position. When the tape is played back for a long period, the cassette may become warm because of the built-in power amplifier. However, this is not a sign of malfunction. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. To obtain the beep tone again, press these buttons again. If you have drink holders near your audio equipment, be careful not to splash juice or other soft drinks onto the car audio. [. . . ] Before going through the checklist below, refer to the operating procedures. Remove the front panel and clean the connectors. There is noise in the space between tracks. A blank space is too short (less than four seconds). [. . . ]