User manual SONY XR-5820R

[. . . ] Make sure the front panel is right side up when attaching it to the unit as it cannot be attached upside down. â· Do not press the front panel too hard when attaching it to the unit. It can easily be attached by pressing it lightly against the unit. â· When you carry the front panel with you, keep it in the supplied case. [. . . ] Note If the automatic tuning stops too frequently, press (SENS/BTM) momentarily until "LCL" light up on the display (local seek mode). Only the stations with relatively strong signals are tuned in. Tip If you know the frequency, press and hold either side of (SEEK/AMS) until the desired station is received (manual tuning). When you tune in an FM station that transmits RDS data, the station name lights up on the display. Note The "*" indication means that an RDS station is being received. Each time you press (DSPL), the displayed items change as follows: Note "NO NAME" lights up if the station received does not transmit RDS data. By using this function, you can continuously listen to the same programme during a longdistance drive without having to re-tune the station manually. The "REG" (regional on) function of this unit lets you stay tuned to a regional programme without being switched to another regional station. (Note that you must turn the AF function on. ) The unit is factory preset to "REG" but if you want to turn off the function, do the following. Press (AF/TA) for more than two seconds until "REG" disappears. When you preset the RDS stations, the unit stores each station's data as well as its frequency, so you don't have to turn on the AF or TA function every time you tune in the preset station. You can select different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. To cancel all traffic announcements, turn off the function by pressing (AF/TA) until "AF" disappears. Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Note that turning the "AF TA" function off stores RDS stations as well as non-RDS FM stations. You can preset the volume level of the traffic announcements beforehand, so you will not miss the announcement. When a traffic announcement starts, the volume will be automatically adjusted to the preset level. Presetting different settings for each preset station Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Press the desired preset number button for two seconds until "MEM" appears. Repeat from step 1 for presetting other stations. If an emergency announcement comes in while you are listening to the radio, the programme will be automatically switched to the announcement. [. . . ] Adjust within three seconds after selecting. (After three seconds the button will again serve as the volume control button. Tip The unit decreases the volume automatically when a telephone call comes in (Telephone-ATT function). To obtain the beep tone again, press these buttons again. [. . . ]