User manual SONY XR-C102

[. . . ] Do not expose cassettes to direct sunlight, extremely cold temperatures, or moisture. When the tape is played back for a long period, the cassette shell may become warm because of the built-in power amplifier. Up to two Sony CD changers (not supplied) can be connected and controlled with the unit by using the Sony source selector (not supplied). Long use of cassette tapes contaminates the tape head causing poor sound quality or complete sound dropout. [. . . ] However, if you press the RELEASE button to detach the panel while the unit is still turned on, the power is automatically turned off in order to protect the speakersfrombeingdamaged. Button for more than two The side facing down is being played. Note Before turning off the unit, eject the tape to avoid tape damage. Note The clock cannot be set unless the power is turned on. Set the clock after you turn on the radio, or during tape playback. To resume playback, press the other fastwinding button partially until the locked button is released. Press either side of the SEEK/AMS/MANU button momentarily to search for the next station (automatic tuning). For lower frequencies For higher frequencies Press either side of the button repeatedly until the desired station is received. When an FM stereo program with a sufficient signal strength is tuned in, Release the button when the desired station is received. When tuning in during driving, use the automatic tuning and the memory preset tuning instead of the manual tuning. Tune in the station which you wish to store on the preset number button. Press and hold the desired preset number button ( 1 to 6 ) for about two seconds. Stations with the clearest reception are automatically searched and memorized on each band (FM I, FM II and AM). Up to 6 stations on each band can be stored on the preset number buttons 1 to 6 in the order of band frequency. The number of the pressed preset number button appears on the display. Up to 6 stations on each band (FM I, FM II and AM) can be stored on the preset number buttons in the order of your choice. Therefore, 12 stations can be memorized on FM. If you try to store another station on the same preset number button, the previously stored station is erased. The unit starts scanning the selected band and memorize the tuned stations on the preset number button 1 through 6 automatically. Press momentarily the preset number button on which the desired station is stored. [. . . ] Output lead Power antenna relay control lead Power amplifier control lead Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. Design and specifications are subject to change without notice. The following checklist assists in the correction of most problems which you may encounter with your unit. Before going through the checklist below, refer to the connection and operating procedures. [. . . ]