User manual SONY XR-C2300R

[. . . ] The numbers in the list are keyed to those in the instructions. The release key 4 is used for dismounting the unit. [. . . ] Connect the yellow cord to a free car circuit rated higher than the unit's fuse rating. If you connect this unit in series with other stereo components, the car circuit they are connected to must be rated higher than the sum of the individual components' fuse rating. If there are no car circuits rated as high as the unit's fuse rating, connect the unit directly to the battery. If no car circuits are available for connecting this unit, connect the unit to a car circuit rated higher than the unit's fuse rating in such a way that if the unit blows its fuse, no other circuits will be cut off. Anslut strömkabeln 5 till enheten och högtalarna innan du ansluter den till den yttre strömanslutningen. Om du seriekopplar enheten till andra stereokomponenter måste den bilkrets de kopplas till ha en högre ampere än summan av de enskilda delarnas amperestyrka. om det inte finns några bilkretsar med en så hög amperestyrka som enhetens ska du ansluta enheten direkt till batteriet. Om inga bilkretsar finns för anslutning till enheten ska du ansluta enheten till en bilkrets med en högre ampere än enhetens styrka så att inga andra säkringar går om enhetens säkring smälter. Warning when installing in a car without ACC (accessory) position on the ignition key switch Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turned off the engine. When you press (OFF) momentarily, the clock display does not turn off and this causes battery wear. The power aerial control lead (blue) supplies +12 V DC when you turn on the unit. When your car has a built-in FM/MW/LW aerial in the rear/side glass, it is necessary to connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. A power aerial without a relay box cannot be used with this unit. Warning If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 5 may damage the aerial. [. . . ] You may need to switch the positions of the red and yellow leads in the car stereo's power connecting cord. After matching the connections and switched power supply leads correctly, connect the unit to the car's power supply. [. . . ]