User manual SONY XR-C300W

[. . . ] Do not install the rotary commander in a place where it may jeopardize the safety of the (front) passenger in anyway. When installing the rotary commander, be sure not to damage the electrical cables etc. [. . . ] Then press the RELEASE button to open up the front panel, and detach the panel by pulling it towards you as illustrated. Align the parts A and B, and push the front panel until it clicks. You may not be able to install this unit in some makes of Japanese cars. Run a blade along the slits on the back of the front trim and cut it off the unit. Bracket Soporte ### ### Bracket Soporte ### Existing parts supplied to your car ### Piezas existentes suministradas con su automóvil ### ### Bracket Soporte ### Existing parts supplied to your car ### Piezas existentes suministradas con su automóvil ### ### This unit is designed for negative ground 12 V DC operation only. Before making connections, disconnect the ground terminal of the car battery to avoid short circuits. Connect the yellow and red power input leads only after all other leads have been connected. Be sure to connect the red power input lead to the positive 12 V power terminal which is energized when the ignition key is in the accessory position. Run all ground wires to a common ground point. When the Unit is Used in a Car with No Accessory Position on the Ignition Key -- POWER SELECT Switch The illumination on the front panel is factory-set to be turned on even when the unit is not being played. However, this setting may cause some car battery wear if the unit is used in a car with no accessory position on the ignition key. To avoid this battery wear when using the unit in such a car, set the POWER SELECT switch located on the bottom of the unit to the B position, then press the reset button. [. . . ] Doing so may damage the active speakers. Therefore, be sure to connect passive speakers to these terminals. [. . . ]