User manual SONY XR-C450W

[. . . ] If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it. ⷠIf no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse. ⷠIf no sound comes from the speakers of a two-speaker system, set the fader control to the centre position. [. . . ] Press (MENU), then press either side of (PRST/DISC) or (PRST) repeatedly until "CLOCK" appears. During playback, press and hold either side of (SEEK/AMS). During playback, press either side of (SEEK/AMS) momentarily for each track you want to skip. You can skip up to nine tracks at one time. If a cassette is already inserted, to start playback, press (SOURCE) repeatedly until "FWD" or "REV" appears. Note The AMS function may not work when: -- the blanks between tracks are shorter than four seconds -- there is noise between tracks -- there are long sections of low volume or quiet sections. Tip The Motion Display mode can be turned off. You can play the tape in various modes: · ATA (Automatic Tuner Activation) turns on the tuner automatically when fast-winding the tape. During playback, press(1) (REP) repeatedly until "REP-ON" in the display appears. Press either side of (PRST/DISC) or (PRST) repeatedly until the desired item appears. Each time you press (­) side of (PRST/DISC) or (PRST), the item changes as follows: "REP" disappears from the display and repeat mode is cancelled. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) until the desired frequency appears (manual tuning). If interference occurs, the "IF AUTO" function of this unit will automatically avoid noise and narrow the reception frequency. In such cases, some FM stereo broadcasts may become monaural. During radio reception, press (MENU), then press either side of (PRST/DISC) or (PRST) repeatedly until "IF AUTO" appears. Note When you widen the frequency signal reception setting ("WIDE" mode), some interference may occur. During radio reception, press (MENU), then press either side of (PRST/DISC) or (PRST) repeatedly until "MONO" appears. Tip The Motion Display mode can be turned off. To return to normal mode, select "MONO-OFF" in step 2. You can also control this unit with the rotary commander (optional). Using the rotary commander the rotary commander works by pressing buttons and/or rotating controls. XR-C5600X/C5500 only: You can also control the optional CD or MD units with the rotary commander. [. . . ] During playback, press (2) (SHUF) repeatedly until the desired setting appears. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. * "SHUF-ALL" is only available when you connect two or more optional CD/MD units. The unit may not function properly if the connectors between the unit and the front panel are not clean. [. . . ]