User manual SONY XR-C500

[. . . ] The release key 4 is used for dismounting the unit. Do not tamper with the four holes on the upper surface of the unit. They are for tuner adjustments to be done only by service technicians. [. . . ] They are for tuner adjustments to be done only by service technicians. Choose the installation location carefully so that the unit will not hamper the driver during driving. Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. Use only the supplied mounting hardware for a safe and secure installation. Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press the OFF button first. Then press the RELEASE button to open up the front panel, and detach the panel by pulling it towards you as illustrated. When the installation and connections are over, be sure to press the reset button with a ball-point pen etc. To a power antenna relay control box do skrzynki przekaºnikowej anteny automatycznej ÍÏ ÍyÚËflÚa Áa yÔpa, ÎeÌËe Ìa peÎeÚo Áa a, ÚoÏaÚË~Ìa aÌÚeÌa motoros antenna relÈdoboz· hoz Í Íopo· Íe peÎe ÍoÌÚpoÎfl ÎeÍÚpË~ecÍoÈ aÌÚeÌÌ° to the +12 V power terminal which is energized in the accessory position of the ignition key switch do przy ±cza + 12V, ktÛre jest zasilane w pozycji kluczyka zap onu, w ktÛrej funkcjonuje wyposaøenie pojazdu (reflektory, wycieraczki itd. To the +12 V power terminal which is energized at all times do przy ±cza + 12V, ktÛre jest zawsze zasilane ÍÏ ÁaxpaÌ, aËfl ËÁ, o c ÌaÔpeÊeÌËe + 12 V, Ìa ÍoÈÚo , ËÌa, , Ë ce Ôoa, a ÚoÍ a +12 V-os, folyamatosan fesz¸ltsÈg alatt · The power antenna control lead (blue) supplies +12 V DC when you turn on the tuner or when you activate the ATA (Automatic Tuner Activation) function. A power antenna without relay box cannot be used with this unit. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. [. . . ] notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. [. . . ]