User manual SONY XR-C5109R

[. . . ] This unit lets you enjoy a variety of features by using a rotary commander. In addition to the tape playback and the radio operation you can expand your system by connecting optional CD/MD unit*. * You can connect to an CD changer, MD changer, or an CD player, MD player. Playing tracks repeatedly -- Repeat play . [. . . ] Press (SEEK/AMS) while the station name is flashing (within eight seconds). The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI seek" appears and no sound is heard). If the unit cannot find another frequency, "NO PI" appears, and the unit returns to the originally selected frequency. Tip When the traffic announcement starts while you are listening to another programme source, the unit automatically switches to the announcement and goes back to the original source when the announcement is over. notes · "NO TP" flashes for five seconds if the received station doesn't broadcast traffic announcements. Then, the unit starts searching for a station that does broadcast traffic announcements. When the "EON" indication appears with "TP" on the display, the current station makes use of broadcast traffic announcements of other stations in the same network. When you preset the RDS stations, the unit stores each station's data as well as its frequency, so you don't have to turn on the AF or TA function every time you tune in the preset station. You can select different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. To cancel all traffic announcements, turn off the function by pressing (AF/TA) until "AF" disappears. Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Note that turning the "AF TA" function off stores RDS stations as well as non-RDS FM stations. You can preset the volume level of the traffic announcements beforehand, so you will not miss the announcement. When a traffic announcement starts, the volume will be automatically adjusted to the preset level. Presetting different settings for each preset station Press (AF/TA) repeatedly and select either "AF", "TA" or "AF TA" (for both AF and TA functions). Press the desired preset number button for two seconds until "MEM" appears. Repeat from step 1 for presetting other stations. If an emergency announcement comes in while you are listening to the radio, the programme will be automatically switched to the announcement. If you are listening to a source other than the radio, the emergency announcements will only be heard if you set AF or TA to on. The unit will then automatically switch to these announcements no matter what you are listening to at the time. Tip If you want to change the preset AF and/or TA setting after you tuned in the preset station, you can do so by turning on/off the AF or TA function. You can locate the station you want by selecting one of the programme types shown below. [. . . ] Outputs Telephone ATT control lead Power amplifier control lead Rear line out (1) Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 2 kg Parts for installation and connections (1 set) Rotary commander RM-X4S Front panel case (1) Bus cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer CDX-605 (10 discs) MD changer MDX-62 Source selector XA-C30 Design and specifications are subject to change without notice. The following checklist will assist in the correction of most problems you may encounter with your unit. Before going through the checklist below, refer to the operating procedures. [. . . ]