User manual SONY XR-C5200

[. . . ] Use only the supplied mounting hardware for safe and secure installation. How to detach and attach the front panel Before installing the unit, detach the front panel. Before detaching the front panel, be sure to press (OFF) first. Press (OPEN) to open up the front panel, then pull it off towards you. [. . . ] Align the front panel to the unit , and push in. First attach 4 to the unit, then insert the unit into 1. Handle the bracket carefully to avoid injuring your fingers. When the installation and connections are are complete, be sure to press the reset button with a ballpoint pen etc. For connecting two or more changers, the source selector XA-C30 (optional) is necessary. Front speakers CD/MD unit Unidad de CD/MD CD/MD-spelare Dispositivo de CD/MD Power amplifier Amplificador de potencia Slutsteg Amplificador de potência Altavoces delanteros Högtalarna framtill Altifalantes dianteiros Front speakers Altavoces delanteros Högtalarna framtill Source selector Selector de fuente Väljare för ljudkälla Selector de fonte Altifalantes dianteiros If there is alternator noise (a whining sound when the engine increases speed), ground the master unit by connecting it to a metal point of the car with the supplied chassis ground cord 9. Connect the ground cord to the master unit with part 2 as shown in the illustration. You can use part 7 to connect the ground cord to the master unit instead of part 2. The release key 5 is used for dismounting the unit. Note The caution alarm for the front panel is not activated when the POWER SELECT switch is set to the B position. When you change the position of the switch, be sure to press the reset button after the connections are completed. The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner or when you activate the ATA (Automatic Tuner Activation), AF (Alternative Frequency) or the TA (Traffic Announcement). A power aerial without a relay box cannot be used with this unit. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. [. . . ] Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the active speakers. Therefore, be sure to connect passive speakers to these terminals. [. . . ]