User manual SONY XR-C6090

[. . . ] This unit lets you enjoy a variety of features by using a rotary commander. In addition to the tape playback and the radio operation you can expand your system by connecting optional CD/MD unit*. * You can connect to an CD changer, MD changer, or an CD player, MD player. Playing tracks repeatedly -- Repeat play . [. . . ] Rotate and hold the control until you locate the specific point in a track, then release it to start playback. If you need to mount the rotary commander on the right side of the steering column, you can reverse the controls operative direction. Press (SEL) for two seconds while pushing in the VOL control. Adjust within three seconds after selecting. (After three seconds the button will again serve as the volume control button. Tip The unit decreases the volume automatically when a telephone call comes in (Telephone-ATT function). You can enjoy clear and powerful bass sound. The D-bass function boosts the low frequency signal with a sharper curve than conventional bass boost. You can hear the bass line more clearly even if the vocal volume remains the same. You can emphasize and adjust the bass sound easily with the D-bass control. This effect is similar to the one you get when you use an optional subwoofer system. Moreover, the Digital D-bass* function creates even sharper and more powerful bass sounds than Analog D-bass. This unit can control a maximum of seven external CD/MD units in this configuretion: CD unit - maximum of five MD unit - maximum of five. Press (SOURCE) until the desired unit indication appears on the display. When a CD/MD unit is connected, all the tracks play from the beginning. Selecting CD/MD units (when several CD/MD units are connected) Each time you press (DSPL) during CD/MD playback, the item changes as follows: $ Elapsed playback time $ Disc name*1 $ Track name*2 $ Clock *1 If there is no prerecorded name for a CD or MD , "NO NAME" appears in the display. *2 If the track name of an MD is not prerecorded "NO NAME" appears in the display. Tip If the name of the MD is too long, only the first eight characters appear in the display. To obtain the beep tone again, press these buttons again. Note If you connect an optional power amplifier to the LINE OUT and do not use the builtin amplifier, the beep tone will be disabled. During playback, press either side of (SEEK/AMS) once for each track you wish to skip the tracks. During playback, press and hold either side of (SEEK/AMS). [. . . ] In order to prevent this, open the front panel by pressing (RELEASE), then detach it and clean the connectors with a cotton swab dipped in alcohol. Otherwise, the connectors may be damaged. Back of the front panel ¡ Reset button (located on the front side of the unit hidden by the front panel) Press this button when you use this unit for the first time, when you have changed the car battery, or when the buttons of this unit do not function properly. Outputs Power antenna control lead Power amplifier control lead Rear line out (1) Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative ground) Approx. [. . . ]